Monitoring, Controlling and Configuring of Wireless Household-Electric Network through Remote Virtual Interface

1
Monitoring, Controlling and Configuring of
Wireless Household-Electric Network through
Remote Virtual Interface

• ?????

2
Abstract

• The objective of this work is to show the
  operation of a system that allows monitoring,
  controlling and configuring a wireless
  household-electric network. The user interface of
  this system is done through a Personal Digital
  Assistant (PDA).

3
INTRODUCTION

• A. Household-electric Network
• B. Handheld
• C. Wireless Communication Networks Technologies

4
Wireless Communication Networks Technologies

• Bluetooth Technology
• ZigBee Technology

5
MOTIVATION

• A key motivation for use of wireless
  technology is the reduction in installation cost,
  since new wiring is not needed. Also, wireless
  network transmits information with minimal
  installation effort. Consequently it has reduced
  maintenance costs.

6
PROPOSAL
7
(No Transcript)
8
(No Transcript)
9
RESULTS
10
Protocol
11
The User Interface
12
(No Transcript)
13
(No Transcript)
14
Modifications in the household-electric

• 1. Circuits that receive a signal from the HC-08
  toclose or to open a key.
• 2.Circuits that read the state of the LEDs in the
  machine and send them to the HC-08.
• 3.Circuits that verify the switch of the
  machines lid and send this signal for the HC-08.

15
CONCLUSIONS

• The results make evident the viability of
  monitoring andcontrolling household-electric
  using wireless communication network and PDA user
  interface. The
• developed architecture allows the substitution of
  the userinterface of a household-electric for an
  equivalent virtual interface. An advantage of
  this new interface is that it will make possible
  the increasing of the security level of the
  household-electric use, through the exhibition of
  a variety of information about the appliance
  lack of water, energy overload, unbalancing load,
  etc