DRILL 516" 4x

1
DRILL 5/16" (4x)
BLOW LED
PROGRESS LEDs
.500
.500
Notes 1. Enclosure Hammond 1590R1BK
2
DRILL 29 (2X)
DRILL 3/4" note 1
DRILL 3/8"
SENSOR BNC
POWER (D3M CONNECTOR)
Notes 1. Use Unibit for large hole. 2. Use D3M
connector as template to confirm location of
mounting holes.
3
1/4-20 DRILL AND TAP note 3
TRIPOD MOUNT
Notes 1. View is looking up at bottom. 2. Hole
is centered. Can locate with diagonals to corners
instead of template 3. 7 drill for 1/4-20 tap
4
MILL 2.70" X .75" note 3
DRILL 1/8" (4X) note 4
DRILL 5/32" (4X) note 5
DRILL 9/32" note 2
ENCODER
Notes 1. View is looking down at top 2. Encoder
hole is centered. Can locate with diagonals to
corners instead of using template. 3. Create
display opening with 1/4" end mill. Opening is
centered side to side and center is 1.5"
from right edge. Check for clearance of display
module mounting holes before milling. 4.
Display mounting holes on precise pattern.
Display mounting holes are centered around
display opening. Check against display
before drilling. 5. Hole pattern for PCB.
Position pattern with respect to encoder hole.
5
LEFT
RIGHT
RIGHT
LEFT
FRONT
REAR
REAR VIEW
FRONT VIEW
6
DRILL 7/16 THRU (8X) note 3
1/4-28 DRILL AND TAP (THRU) SPOTFACE 0.5" notes
1,2
Notes 1. 3 drill for 1/4-28 tap 2. Spot face
with 1/2" end mill optional, but desirable. Go
down about .01. 3. Hole pattern is on 1.00"
centers. Can drill with mill if desired.