The TRD High Voltage Distribution System Athens University P' Mantzaridis, A' Markouizos, P' Mitseas - PowerPoint PPT Presentation

1 / 13
About This Presentation
Title:

The TRD High Voltage Distribution System Athens University P' Mantzaridis, A' Markouizos, P' Mitseas

Description:

A Master/Slave power supply distribution system has been designed in order to ... Overcurrent and short circuit protection for HV output (software control) ... – PowerPoint PPT presentation

Number of Views:217
Avg rating:3.0/5.0
Slides: 14
Provided by: physiUnih
Category:

less

Transcript and Presenter's Notes

Title: The TRD High Voltage Distribution System Athens University P' Mantzaridis, A' Markouizos, P' Mitseas


1
The TRD High Voltage Distribution SystemAthens
University P. Mantzaridis, A. Markouizos, P.
Mitseas, S. Potirakis, M. Tsilis, M. Vassiliou
2
Outline

Introduction HVDS SpecificationsPrototy
pe HVDS Installed at P2 HVDS Pictures Block
diagramHVDS Architecture CAN Commands List
3
TRD
540 individual modules18 azimuthal
sectors-supermodulesEach supermodule contains
5 detector stacks of 6 module layers each
Introduction
ALICE TRD
HVDS Description
  • A Master/Slave power supply distribution system
    has been designed in order to provide the
    required anode and drift voltage to the ALICE TRD
    readout chambers.

  • The system will be used to switch on and off,
    monitor (on the nA level), protect, and regulate
    (leverage of 1000 Volts) from a common ceiling
    voltage.

4
HVDS Specifications

Anode System Dynamical range 900 1900
V Max. Output current 6.3 uA Drift
System Dynamical range 1450 2500 V Max.
Output current 270 uA Both Systems Output
Channels 30 installed (540) ramp-up
rate 1-30 V/s ramp-down rate 1-100 V/s volt
age stability DV lt 50 mV
/24h Overcurrent and short circuit protection
for HV output (software control), response
time lt 50 ms
5
Prototype HVDS Installed at P2


6
Prototype HVDS Installed at P2


7
Electrical Power Safety Measures
8
HVDS Card Image



Edw na mpei fwto tis pisw pleuras
9
HVDS Block diagram


10
  • MAIN
    COMPONETS
  • Master Voltage where a nominal ceiling voltage is
    provided to the Slave system
  • Reed Relay to switch on-off the power to a single
    chamber
  • LOW VOLTAGE SITE COMPONENTS
  • Shunt Regulator (H.V transistor)
  • Adder amplifier, Error amplifier and a switching
    off transistor!
  • High Accuracy Voltage Divider(500MOhm)
  • 24 bit 6 S?ADC for measuring the output voltage
  • Microcontroller
  • Auxiliary power supply
  • HIGH VOLTAGE SITE COMPONENTS
  • Current Sensing Resistor
  • High precision Ultra Low noise and input current
    amplifiers
  • Single 24 bit S?ADC 3in3out Optoisolators
  • Auxiliary power supply per channel

11
HVDS Architecture
  • Architecture Similar to ALICE TRD layout

12
(No Transcript)
13
(No Transcript)
Write a Comment
User Comments (0)
About PowerShow.com