All You Need To Know About Ferrites in Broadband Transformers

1
(No Transcript)
2
All You Need To Know About Ferrites in Broadband
Transformers
3
Broadband Transformers are magnetic systems used
to transfer energy over different frequencies.
They are wound on ferrite cores, such as
toroidal cores POT cores for their higher
permeability, higher efficiency, excellent RFI
performance, good frequency response, no
leakage magnetic flux. One of the common
applications of these transformers is
tele ommunication equipment, where they are used
widely at low power levels. In this blog, were
going to take a closer look at broadband
transformers, their purpose how they use
ferrites to boost their operations. Lets get
started!
4
Types of Broadband Transformers

1. Conventional Transformers These transformers
   transfer electrical energy from one circuit to
   another at a similar frequency but at different
   voltage. Their work is based on the principle of
   electromagnetic induction. Theyve two windings-
   primary secondary, similar to power audio
   transformers.
2. Transmission Line Transformers These
   transformers are usually wounded on ferrites or
   powdered iron cores while using parallel
   windings. They are more efficient than the
   conventional ones. For example, balun
   transformers.

5
Purpose of Broadband Transformers
Broadband transformers are meant to work in
different frequencies where both XL or XC have
their unique one or more frequency ranges. For
this, you need to use ferrite cores with
high-permeability that have small windings as
desired for the MF HF spectrums. When the
operating frequency increases, the core becomes
obvious to the circuit. An important parameter
in transformers is shunt reactance, which
increases with frequency. But this only happens
if the permeability of the material is constant
or decreasing at a rate lesser than the increase
in frequency.
6
How are Ferrites used in Broadband Transformers?
Ferrites are the most appropriate
cost-effective material used in broadband
transformers. They provide the highest impedance
in the frequency of unwanted noise signals
always have a high initial permeability at lower
cut-off frequency. Usually, ferrites ar selected
depending on their characteristics, such as the
ease of winding terminating some technical
design constraints of the transformer. For
example, Manganese Zinc (MnZn) ferrites are
suitable for the low medium frequency
transformer designs. When these ferrites are in
the broadband transformers, the core geometry
should be the ratio of DC resistance to the
inductance for a single turn, which is minimum.
7
For transformers that have an overlaying direct
current, gapped ferrite cores can control the
reduction in shunt inductance. On the other hand,
high-frequency transformers are well-suited with
toroidal core-shaped ferrites. A few turns that
are needed can be wounded on the toroid. But
keep a note that windings with lesser turns lead
to issues in obtaining the desired impedance
ratios. To minimise the leakage inductance, the
primary secondary windings are coupled.
8
Thank You
Get Social https//www.facebook.com/cosmoferritesl
td/ https//twitter.com/Cosmo_ferrites
https//in.linkedin.com/company/cosmo-ferrites-lim
ited www.cosmoferrites.com