Important Guidelines for Split AC Installation PowerPoint PPT Presentation

presentation player overlay
About This Presentation
Transcript and Presenter's Notes

Title: Important Guidelines for Split AC Installation


1
Important Guidelines for Split AC Installation
The installation of the split air conditioners is
a crucial job. Accurately installed air
conditioner will give optimum cooling. If it is
not done properly, you wont get the desired
cooling effect. Poor air conditioning
installation Canberra leads to frequent
maintenance problems.
https//www.oldmateact.com.au/
2
https//www.oldmateact.com.au/
3
Important Factors to Consider During the
Installation of Split Air Conditioner
Strength of Wall to Hold the AC
  • The indoor unit of the split AC must be installed
    on a wall strong enough
  • Proper spacing between wall and AC unit
  • The indoor unit of the split AC requires at least
    15 cm of open space surrounding

https//www.oldmateact.com.au/
4
Appropriate Installation Height From Ground
  • Experts of reverse cycle air conditioning service
    say that the indoor unit of the split AC should
    be installed at a height of 7-8 feet above the
    ground
  • There should be adequate cooling inside the room

https//www.oldmateact.com.au/
5
Correct Tilt Angle of Indoor Unit
  • Slight angle is needed to ensure unrestricted
    flow of the condensed water from the drain pipe

https//www.oldmateact.com.au/
6
Correct Location of Outdoor Unit
  • Proper cooling is ensured only when indoor and
    outdoor units of split AC are located away from
    direct sunlight and water
  • Install the outdoor unit of the split AC in open
    space so that there is no hindrance to the heat
    dissipated from the condenser

https//www.oldmateact.com.au/
7
Proper Placement of Outdoor Unit
  • An outdoor unit of the split AC must be placed on
    a flat and rigid surface
  • Outdoor unit has some key components of the split
    AC like compressor, condenser, fan motor, etc.
  • If not on a flat surface, it will vibrate
    excessively
  • This will lead to the breakage of copper pipes,
    coolant leakage and compressor/condenser damage

https//www.oldmateact.com.au/
8
Oldmate ACT Pty Ltd
https//www.oldmateact.com.au/
E-Mail office_at_oldmateact.com.au
tim_at_oldmateact.com.au Office 02 6254
6576
https//www.oldmateact.com.au/
Write a Comment
User Comments (0)
About PowerShow.com