To set up your Nighthawk Tri-band Extender using WPS

1
To set up your Nighthawk Tri-band Extender using
WPS

• For Help Just Call Us At Our Toll-Free Number
  (866)-302-4260
• For More Know About Visit Our Website -
  https//www.mywifiextnet.xyz

2
Want to extend the range of your currently
configured network? If yes, then you need an
extender. This extender will be configured on the
Wi-Fi network so, you must connect it to the
existing wireless network. There are two ways to
connect the Nighthawk wireless range extender to
the network. Today, we are going to discuss the
installation guide with respect to Nighthawk
wireless extender. We will discuss the steps to
configure this device with the help of Netgear
Installation assistant.
3
(No Transcript)
4
wifi range extender
Connecting via WPS WPS stands for Wi-Fi
protected setup. With this method, you can
connect your extender directly to the network
without requiring any username and password. For
complete information about it, you can go to
Netgear Nighthawk extender setup link.
5
www mywifiext net
Connecting with Netgear installation assistant
To use this assistant, you need to open a web
browser from your PC or smartphone. Now, we are
going to discuss the steps to setup Wireless
range extender with the Netgear installation
assistant.
6

• Switch on your extender by connecting it to the
  power supply.
• Place the Nighthawk extender near to the Wi-Fi
  router.
• Plug the extender into the electrical socket.
• Wait for some seconds till the power light on it
  turns green. If you find no power light on the
  device, then press the power button from the rear
  of the extender.

7

• Connect your extender to the computer or
  smartphone using wireless or Ethernet device.
• With Wi-Fi From your Wi-Fi enabled smartphone or
  laptop, open connection manager and connect to
  the Network with name Netgear_Ext. You will find
  this network name in the list of networks.
• Once the extender gets connected to the Wi-Fi
  enabled computer or device, a client LED will
  turn white.

8

• With Ethernet If you want to connect your
  computer to the extender with Ethernet, then
  connect one end of this cable to the extender and
  another end to the computer.
• Open a web browser like Chrome or Firefox on your
  computer and type www.mywifiext.net.
• You will find a Netgear installation page on the
  screen.
• Follow on-screen instructions to connect your
  Netgear extender to the Wi-Fi network.

9

• Now, change the place of your extender from the
  current position. Place it exactly in the midway
  between the router and the blackspot area.
• You must ensure that the area where you have
  placed your extender must be capable of receiving
  a signal from your router. You can select the
  right area with the help of status LED engrossed
  on the extender. If the status LED turns white,
  then it means the area is getting sufficient
  signal from the router.

10
www.mywifiext.net

• In case the signal received at the extender is
  not proper or poor, then you will have to change
  the direction of the extender. Move the extender
  close to the router. Check the status LED now. If
  it is white, then the location is OK.
• Once the connection gets established, you can
  start connecting the wireless devices to the
  newly configured Wireless range extender.

11
This is all about the setup steps. For more
information and support, you can go to How to
configure Nighthawk extender link. A complete
information is available on this page.
12
(No Transcript)