Dana 60 disc brake conversion kit

1
Dana 60 disc brake conversion kit

• Front disc brakes can every so often have a
  hassle that sneaks up on you. When a vehicle
  pulls to one facet when braking, its no longer
  continually substantial at first, however can
  subsequently get worse, creating an hazardous
  using condition which may want to lead to loss of
  driver control. It might also not be evident at
  gradual speeds however a panic - end or hard
  braking in a nook can surprise a driver if the
  automobile pulls to one aspect when braking. This
  braking circumstance needs to be corrected
  immediately.
• Front brake calipers are designed to 'float' or
  slide on their mounting surfaces. You must have
  the Dana 60 disc brake conversion kit. Dirt,
  street grime, brake pad dust, and floor rust can
  build up between these surfaces inhibiting the
  calipers to slide properly. One caliper can be
  slower to take hold of than the other, which is
  why the car pulls to one facet when braking. Most
  would anticipate that oil or grease may
  additionally have contaminated the brake pads
  but this is now not always the case.

2

• There is an effortless fix if your car pulls to
  one side when braking. Raise the automobile and
  remove wheel. Unbolt brake caliper and carry off
  of mounting bracket. Don't let it hang via the
  brake hose, put a jack stand or block of wood
  beneath it for support. Inspect the mating
  surfaces of both the brake caliper and mounting
  bracket. Using emery material or sandpaper, sand
  these surfaces to eliminate any build-up of rust,
  brake pad cloth or street dirt. Wipe areas smooth
  with a save rag, repeating the process till all
  mounting surfaces are smooth and smooth.
• Put a dab of high-temperature disc brake bearing
  grease on all the mating surfaces be careful to
  avoid getting any on brake rotor or pads. Using
  your finger spread the grease on the easy
  surfaces to allow the grease to get in the pores
  of the metal. Wipe off any excess. Reinstall
  brake caliper, use brake cleaner to spray off any
  grease that may additionally have touched brake
  pads or brake rotor. Repeat procedure for other
  aspect with Dana 60 disc brake conversion kit.

3

• Test drive vehicle on a straight road at gradual
  speeds, follow brakes, and feel for any pulling
  sensation. Test at distinctive speeds. Pat
  yourself on the back for a job well-done, and the
  money you saved by means of doing it yourself.
• For more information Mail id- gubni2_at_gmail.com,
  Contact Number- 1 423-737-0265,
  http//lugnut4x4.com.