Turning Between Centres

1
Turning Between Centres
2
1) Using a Tenon Saw and Saw Board cut your piece
of wood to length
Add 20mm extra to each end to allow for holding
the wood on the lathe.
3
2) Next use a rule to find the centre of each end.
3) Use a set of compasses to mark a circle on
each end.
4
4) Use a Jack Plane to plane each corner down to
the edge of the circle.
5
5) Plane all 4 corners
6
6) Make a large hole in one end with a bradawl
7
7) Use a Tenon saw to cut a V shaped slot in the
other end.
8
8) Fit the wood to the lathe between the Forked
Centre and Revolving Centre
9
The End