Gap Acceptance - PowerPoint PPT Presentation

1 / 11
About This Presentation
Title:

Gap Acceptance

Description:

Gap Acceptance. Sight Triangles. A Approach Sight Triangles. B Departure Sight Triangles ... ISD = intersection sight distance. for turning left from stop ... – PowerPoint PPT presentation

Number of Views:238
Avg rating:3.0/5.0
Slides: 12
Provided by: FHWA52
Category:
Tags: acceptance | gap

less

Transcript and Presenter's Notes

Title: Gap Acceptance


1
Gap Acceptance
Sight Triangles
Clear Sight Triangle
Clear Sight Triangle
A Approach Sight Triangles
Clear Sight Triangle
Clear Sight Triangle
B Departure Sight Triangles
2
Intersection Sight Distance
94 GB 90 GB
2001 GB
Speed
ISD
ISD
80 km/h
250 m
170 m
50 mph
840 ft
555 ft
ISD intersection sight distance for
turning left from stop onto major highway
3
Offset Left - Turn Lanes
Advantages
  • Better visibility
  • Reduced conflict
  • More vehicles served

Parallel
Tapered
4
Miscellaneous
  • Horizontal control see Chapter 3
  • Deceleration length
  • Discussion revised
  • Additional design speeds and values included
  • Discussion on driveways expanded

5
Chapter 10 Grade Separations and Interchanges
Access separations and control on
crossroad at interchanges
Turning roadway widths Single - point urban
interchanges Superelevation and cross
slopes Two lane entrance ramps
6
Miscellaneous
  • Recommends separation of bicycle/pedestrian
    movement from vehicle movement through
    interchanges
  • Single Point Urban Interchange discussed as
    separate type
  • Exhibit 10-67 made consistent with Exhibit
    3-55

7
Access Control at Interchanges
Minimizes spillback on ramp crossroad Distance
for crossroad weaves Distance for merging
maneuvers Provides storage for turning vehicles
8
Miscellaneous
  • Cautions against the use of minimum values
    for taper type entrances
  • Exhibit 10-70 Acceleration lengths have been
    recomputed
  • Adds a caution concerning volumes exceeding lane
    capacity on 2-lane ramps

9
Technical Corrections
  • Exhibit 3 - 55 and Exhibit 10 - 67 - In
    metric side, under Case I column, replace
    with with no so it is identical with
    US Customary.
  • Exhibit 3 - 76 - Delete and Sag from
    title.
  • Exhibit 5 11 - Replace 5.5 under
    residential in the metric side with 2.2.

10
Technical Corrections
  • Exhibit 10 - 60 is incorrect. It should be
    similar to Figure IX-66 in 94 GB.
  • Exhibit 10-71 - In the metric side under
    the column All Speeds, change 3 to 4
    Downgrade to 5 to 6 Downgrade

11
Future Research
Truck impacts on criteria ( underway
) Improved design for freeway speed change
lanes ( proposed ) Design criteria and
warrants for right turn deceleration (
proposed ) Auxiliary through lanes and lane
drops ( proposed ) Passing sight distance (
proposed )
Write a Comment
User Comments (0)
About PowerShow.com