GEO600: building a gravitational wave observatory - PowerPoint PPT Presentation

About This Presentation
Title:

GEO600: building a gravitational wave observatory

Description:

GEO600: building a gravitational wave observatory – PowerPoint PPT presentation

Number of Views:47
Avg rating:3.0/5.0
Slides: 19
Provided by: lip74
Category:

less

Transcript and Presenter's Notes

Title: GEO600: building a gravitational wave observatory


1
GEO600 building a gravitational wave observatory
  • Martin Hewitson
  • AEI, Hannover
  • for the GEO team

2
International network of ground-based detectors
GEO600
VIRGO
LIGO detectors
AURIGA, EXPLORER NAUTILUS
TAMA300
ALLEGRO
NIOBE
bar detectors
Bar detectors
Interferometers
interferometers
3
GEO600 Hannover, GERMANY
4
GEO600 optical layout
North arm
4m
East arm
1.5kW
1.6W
12W laser system
Attenuate to 5W
Power-recycling mirror
600m
Signal-recycling mirror
35mW
5
Control room
1.5kW _at_ BS
MCN
BS
MCE
PR (0.09)
SR (2)
1.6W
output detector
MC 1
5W
MC 2
6
Design sensitivity
  • Signal-recycling cavity tuned to be resonant at
    1kHz

7
Test-mass Suspensions
8
Locking scheme
  • Power-recycling
  • Michelson
  • Signal-recycling

9
Measured optical transfer functions
V
dL
Amplitude (A.U.)
Phase (deg)
Frequency (Hz)
10
Data flow
  • 64 high fs
  • 64 mid fs
  • gt1000 low fs

11
Calibration I
Michelson servo model
  • Correct for Michelson servo and optical gain
    response

TF Strain ? detector output
x
Optical cavity model

12
Calibration II
CAL
P and Q
actuator
optical
dL
V
V
Use IIR filters to calibrate detector outputs to
two strain channels
13
Calibration III
  • Maximum likelihood estinmator for h(t)
  • Use noise-floor estimates to get weights
  • Convert weights to filters

14
On-line monitoring and remote operation
  • LabVIEW system guides analog loops
  • Low-latency data viewing systems

15
Commissioning
  • Implementing subsystems
  • Mostly done now
  • New laser still needed
  • Stability
  • Lock-loss investigations, alignment control
  • Sensitivity
  • Noise hunting
  • Feedback systems, light and modulation noise,
    other
  • Use noise-projections, intuition
  • Data quality
  • Stationarity, glitch rate, lines

16
Noise-projections
  • Measure TF from source to detector output
  • Measure PSD at source
  • Multiply to project source to main output

17
Sensitivity progress
hrms/?Hz
Frequency (Hz)
18
S4 Science run - statistics
  • 4 Week science run in coincidence with LIGO
    detectors
  • 708 hours of science data
  • Duty cycle 95
  • Longest lock 50 hours

19
The way forward
  • Tune to lower signal-recycling resonance (300Hz)
  • Noise hunting focusing at the lower frequencies
    (100-1000 Hz)
  • Feedback noise, laser amplitude noise
  • Turn up laser power (?5)
  • New laser setup
  • Continue to work towards design sensitivity
  • S5 extended science run (gt1 year)
  • Starting end 2005
Write a Comment
User Comments (0)
About PowerShow.com