Back%20Trajectory%20Techniques%20in%20Air%20Pollution - PowerPoint PPT Presentation

About This Presentation
Title:

Back%20Trajectory%20Techniques%20in%20Air%20Pollution

Description:

Such fluid particles, marked' at a certain point in space at a given time, can ... Potential temperature, isentropic potential vorticity ... – PowerPoint PPT presentation

Number of Views:257
Avg rating:3.0/5.0
Slides: 39
Provided by: gtg
Category:

less

Transcript and Presenter's Notes

Title: Back%20Trajectory%20Techniques%20in%20Air%20Pollution


1
Back TrajectoryTechniques in Air Pollution
Farhan Akhtar Benton Whitesides Bo
Yan 11/19/2003 EAS 6792
2
Definition
  • Trajectories the paths of infinitesimally small
    particles of air as they move through time and
    space.
  • Such fluid particles, marked at a certain point
    in space at a given time, can be traced forward
    or backward in time along their trajectory.
  • Backward (back) trajectories
  • indicate the past path of a particle
  • Forward trajectories
  • indicate the future path of a particle

3
Example Back Trajectory
7-day Back trajectories from the ship (receptor)
have been calculated using the HYSPLIT 4 model
(HYbrid Single-Particle Lagrangian Integrated
trajectory).
receptor
4
Applications of Back Trajectories
  • Synoptic meteorology
  • Investigate air mass flow around mountains
    (Steinacker, 1984)
  • Climatology
  • Identify pathways of water vapor transport
    (DAbreton and Tyson, 1996) or desert dust
    (Chiapello et al., 1997)
  • Environmental Sciences
  • Establish source-receptor relationships of air
    pollutants (Stohl, 1996a)
  • Law Enforcement
  • Combine with pollen measurements to find possible
    locations of marijuana cultivation (Cabezudo et
    al.,1997)

5
Calculation of the Back Trajectory
X - the position vector during a time step dt
resulting from the wind v - mean wind
velocity vector (no consideration the turbulent
mixing in atmosphere)
6
Calculation of the Back Trajectory (contd)
If known x0 at t0
7
Error Sources in the Computation of Back
Trajectories
  • Wind field errors
  • In many cases, they are the largest single source
    of errors for back trajectory calculations. Wind
    field errors can be due to either analysis or
    forecast errors.
  • Starting position errors and amplification of
    errors
  • The starting positions of the trajectories are
    often not exactly known
  • Difficult to select start positions due to the
    differences between the model topography and the
    real topography
  • Back trajectory position errors can be strongly
    amplified in convergent flow.

8
Error sources for the computation of back
trajectories (cont)
  • Truncation errors
  • They come from the trajectory equation solution,
    which is approximated by a finite-difference
    scheme that neglects the higher order terms of
    Taylor series. In order to keep truncation errors
    negligible, a numerical scheme of high order
    using very short time steps is needed.
  • Interpolation errors
  • Due to the limit available wind data, wind speed
    must be estimated at the trajectory position. The
    interpolation errors will be caused during the
    process.
  • Errors resulting from assumptions regarding the
    vertical wind
  • Because there are no routine observation of
    vertical wing component w, Wind field of w can
    only gotten from meteorological model. So, it is
    less accurate than the horizontal wind fields.

9
Lagrangian Particle Dispersion Models (LPDM)
  • V - mean wind vector obtained directly from
    meteorological model
  • V - turbulent wind vector describing the
    turbulent diffusion of the tracer in the PBL.

10
Lagrangian box models
  • Similar to LPDM, changes in the concentrations in
    the box caused by chemical reactions and
    deposition are calculated.
  • No boundary conditions are required.
  • Applicable only at higher levels of the
    atmosphere
  • The most important boundary layer processes, such
    as the formation of nighttime reservoir layers or
    the rapid growth of the mixed layer depth in the
    morning, can be described with such models
    (Hertel et al., 1995),

11
Statistical analyses of trajectories
  • Flow Climatologies
  • Cluster analysis
  • Residence time analysis and conditional
    probability
  • Concentration fields
  • Redistributed concentration field
  • Inverse modeling

12
Accuracy
  • Measure of the integral effect of all errors
  • Determined by following the movement of conserved
    tracers
  • Balloons
  • Stay at a constant pressure height
  • Do not measure vertical errors
  • Material Tracers
  • Conservative species are monitored.
  • Compare results with Meteorological measurements
  • Dynamical Tracers
  • Attempt to model vertical movement in the
    atmosphere
  • Potential temperature, isentropic potential
    vorticity

13
Examples Applications of Back-Trajectory
Techniques
Determination of Regional Sources of Winter Smoke
Pollution in New Zealand Tajectory analysis of
particulates in Big Bend national park
14
Determination of Regional Sources of Smoke
Pollution in Winter
  • Night time burning of wood and coal in domestic
    fires created smoke pollution for the town of
    Christchurch, New Zealand.
  • In the evening, temperature inversions trap
    pollution close to the surface.
  • Burning created high concentrations of
    particulate matter from the ground to 10m.
  • Used back-trajectory models to determine origin
    and pathways of polluted parcels.

15
PM10 and CO Concentrations
  • Winter 1988-1999 averaged concentrations in
    Christchurch for a 24 hour period.
  • Reveals Diurnal cycle of PM10 peaking over night.

16
Region of Interest
  • City of Cristchurch New Zealand
  • Plains to the North and West
  • Hills to the South
  • Water to the East

17
Complexities
  • Terrain creates complexity in low level flow.
  • On clear calm nights, radiative cooling of hill
    slopes causes cold air drainage into the region
    of interest.

18
Techniques
  • Only enough data to use simple back-trajectory
    techniques.
  • Lagrangian Kinematic Back-Trajectory Modeling
    techniques.
  • Regional Atmospheric Modelling System (RAMS)
    based on averaged nocturnal wind fields typically
    associated with high pollution events in the city
    (1995-2000).

19
Nested Grid Model
  • RAMS is a 3-D Nested Grid Model allowing focus on
    specific regions.
  • No vertical grid nesting- focus on lowest km of
    atmosphere (damping applied to higher altitudes).

20
Techniques
  • Models air flow of 4 Cases
  • No initial wind
  • Weak NW wind
  • Strong SW wind
  • Moderate NE wind
  • Resolution (Spatial 500m) (Temporal 15 mins)
  • Run times 3pm to 3am
  • 2nd Order Turbulence Closure

21
Model Vs. Observations
  • Model recreation of the horizontal wind field
    compares well to actual observations.
  • Other methods of comparison included standard
    deviation root-mean square.
  • Using these wind fields, back trajectories
    plotted for given endpoints.

22
Problems
  • Ignored particle settling rates.
  • Vertical velocities neglected (though realistic
    for night)
  • No examination of concentration changes in
    parcels during transport.
  • No consideration of sources of sinks during
    transport (chemical photochemical reactions).
  • Synoptic events not considered

23
Back Trajectory Plots
  • Trajectory plots show parcel path across grid
    space from surrounding regions.
  • Urban area of Christchurch is represented by grid
    dots.

24
Results No Initial Wind
  • Surface airflow dominated by local effects (cold
    air drainage from hills).
  • Air originates in plains and moves towards the
    city, except for near the hills where cold air
    drainage occurs.

25
Results Strong SW Wind (10 m/s)
  • Gradient wind -dominates transport,
    -turbulent mixing and -inhibits inversion
  • No impact from cold air drainage.
  • Air travels much farther.

26
Results Light NW Wind
  • Similar to what happens with no initial wind.
  • Terrain dominates transport (cold air drainage).
  • Transport almost independent from wind.
  • Parcels move from hills into city.
  • (As expected from cold air drainage)

27
Results Moderate NE Wind
  • Very different from other cases
  • Air blowing on shore.
  • Seabreeze orographic wind switch direction as
    drainage develops.
  • Air re-circulates over city allowing evening
    pollution buildup.
  • Hills less important.

28
3 Back Trajectories From NE Wind
  • Note recirculation of parcels over the city with
    changing winds.
  • Grey dots indicate endpoints of each trajectory.

29
Implications Conclusions
  • Cold Air Drainage allows leakage of southern hill
    pollutants into city and northern valleys
    overnight.
  • Drainage can be inhibited by stability.
  • Burning during winter (problematic months) should
    be restricted.

30
Particulates in Big Bend National Park
31
Background
  • Park has registered the poorest visibility in the
    western United States.
  • Since 1988, fine particulate matter and optical
    data has been collected in the park
  • The majority of the visibility degradation is due
    to sulfate particles.
  • Large coal-fired power plants are located over
    the border into Mexico.
  • Use a LPDM to determine the sources for these
    particulates

32
LPDM Inputs
  • The depth of the transport zone is set at the
    lowest inversion layer which meets these
    criteria
  • height is at least 300 m above the ground
  • Potential temperature lapse rate of at least 5
    K/km
  • Potential temperature is 2K greater at the top
    than at the bottom
  • If no inversion exists, 3000m is assumed
  • Horizontal winds are linearly interpolated from
    rawinsonde measurements
  • Computed backward in 6h time steps for a maximum
    of 120h (5 days)

33
Accuracy and Errors
  • Rainout and especially low inversion layers are
    not accounted for
  • Trajectories are aggregated over long time
    periods to attempt to minimize errors

34
Results
  • If over 80 of the trajectories calculated for a
    day came from one country, the day was assigned
    to that country.
  • 935 days from 10 years were analyzed
  • The model indicates that most particles (59)
    came from Mexico.

35
Results by season
Overall source attribution from 1989-1998
36
Results by season
Overall source attribution for fine sulfur from
1989-1998
37
Results by season
Overall source attribution for organic carbon
from 1989-1998
38
References
Gebhart, Kristi A., et al., Back-trajectory
analyses of fine particulate matter measured at
Big Bend National Park in the historical database
and the 1996 scoping study. The Science of the
Total Environment. Vol 276. Elsevier 2001.
pp.185-204. Stohl, A. Computation, Accuracy and
Applications of Trajectories- A Review and
Bibliography. Atmospheric Environment. Vol 32.
Pergamon 1998. pp. 947-966. Stohl, A., et. al.
A replacement for simple back trajectory
calculations in the interpretation of
atmospheric trace substance measurements.
Atmospheric Environment. Vol 36. Pergamon
2002. pp. 4635-4648. Sturman, A., P. Zawar-Reza.
Aplication of back-trajectory techniques to the
determination of urban clean air zones.
Atmospheric Environment. Vol 36. Pergamon
2002. pp. 3339-3350.
Write a Comment
User Comments (0)
About PowerShow.com