DRAWSTRING BAG INSTRUCTIONS READ THE DIRECTIONS CAREFULLY AND CHECK OFF EACH STEP AS YOU COMPLETE IT BEFORE GOING ON TO THE NEXT STEP - PowerPoint PPT Presentation

About This Presentation
Title:

DRAWSTRING BAG INSTRUCTIONS READ THE DIRECTIONS CAREFULLY AND CHECK OFF EACH STEP AS YOU COMPLETE IT BEFORE GOING ON TO THE NEXT STEP

Description:

title: drawstring bag instructions read the directions carefully and check off each step as you complete it before going on to the next step author – PowerPoint PPT presentation

Number of Views:46
Avg rating:3.0/5.0
Slides: 3
Provided by: Tria531
Category:

less

Transcript and Presenter's Notes

Title: DRAWSTRING BAG INSTRUCTIONS READ THE DIRECTIONS CAREFULLY AND CHECK OFF EACH STEP AS YOU COMPLETE IT BEFORE GOING ON TO THE NEXT STEP


1
DRAWSTRING BAG INSTRUCTIONSREAD THE DIRECTIONS
CAREFULLY AND CHECK OFF EACH STEP AS YOU COMPLETE
IT BEFORE GOING ON TO THE NEXT STEP
  1. Measure and tear fabric so that it is a 12 x 18
    rectangle. You will also need to tear a 2 1/2 x
    24 piece of fabric for the drawstring.
  2. Turn fabric so that the top edge of the bag is
    closest to you (as in the diagram). Be sure that
    the fabric is RIGHT SIDE UP. Using a ruler and a
    marking pencil, draw a line 1 from the edge and
    another line 2 from the top edge (the one
    closest to you.
  3. Fold the bag from left to right. On the torn
    edge, measure up 3 and 3 3/4 from the top edge.
    Mark these points with a 1 long line.
  4. Pin the bag together as it is folded, making sure
    that the top (where you drew the long lines) is
    NOT pinned. Stitch a 5/8 seam beginning at the
    bottom of the bag, pivoting at the corner
    (Remember to backstitch when you start). Stitch
    to the first mark. Backstitch, lift the presser
    foot, and slide the fabric to just past (1/4)
    the second marking. Backstitch to the mark, then
    stitch forward to the edge. End with a
    backstitch.
  5. Finish the drawstring bag edges with a zig zag to
    prevent fraying. Only stitch on the edges where
    you did the straight stitching. DO NOT stitch
    where you left the 3/4 opening.

2
  • With your scissors, clip to BUT NOT THROUGH the
    stitching at the small opening for the
    drawstring. Press open.
  • Fold top edge of the wrong side on the 2 line.
    Pin as in the diagram. Turn right side out.
    Check to make sure that folded section completely
    covers the drawstring hole. Stitch along the 1
    line. Stitch again with the presser foot guiding
    along the zig-zagged edge. Turn right side out
  • To make the drawstring, fold and pin the fabric
    lengthwise, RIGHT SIDES TOGETHER. Sew a 1/4
    seam, leaving one end open. Turn right side out.
  • Roll the seam between your fingers until it is
    exactly on the edge. Press.
  • Using a decorative stitch of your choice, top
    stitch the drawstring on both edges, guiding
    along the inside toe of the presser foot.
Write a Comment
User Comments (0)
About PowerShow.com