How to Install Brass Threaded Inserts in Wood and Metal? - PowerPoint PPT Presentation

View by Category
About This Presentation
Title:

How to Install Brass Threaded Inserts in Wood and Metal?

Description:

The process of installation looks difficult, but it is easy if done systematically.When you consider threaded brass inserts, then a straight brass barrel with a single slot and ultra-thin external thread are the most popular one. It is tapered so that it can be guided through the hole straighter without a difficulty.If you are looking for Install brass threaded inserts in wood and metal your search ends here. – PowerPoint PPT presentation

Number of Views:3

less

Write a Comment
User Comments (0)
Transcript and Presenter's Notes

Title: How to Install Brass Threaded Inserts in Wood and Metal?


1
How to Install Brass Threaded Inserts in Wood and
Metal?
http//vebrassinserts.com/
2
Installing Brass Threaded Inserts
When you consider threaded brass inserts, then a
straight brass barrel with a single slot and
ultra-thin external thread are the most popular
one.
3
Brass Threaded Inserts in Wood and Metal
  • Another variation is available that has wide
    threads and a hex wrench slot.  It is tapered so
    that it can be guided through the hole straighter
    without a difficulty.
  • According to the experts, using an unplugged
    drill press and bolt (to support the insert) is
    the most foolproof way of inserting a threaded
    brass insert into the metal or wood.
  • To keep the insert square to the board a drill
    press is used. The process of installation looks
    difficult, but it is easy if done systematically.

4
Process of Installation
  • The method of insertion is a multi-stage
    process. Lets understand it in detail.
  • Drill a hole in the piece of wood as per the size
    recommended. It is imperative to do it highly
    precisely. Make sure the drill press is unplugged
    once the work is over.
  • The next step is to cut off the head of the bolt.
    It is done with the help of same thread as the
    insert. It is supposed to be inserted and fixed
    to the chuck.
  • Insert a nut and washer onto the bolt by spinning
    it. You need to make it tight as much as
    possible.
  • The next step is to center the hole under the
    insert. You can fix it by clamping the piece down
    to the drill press table.  The insert should be
    advanced into the hole until they contact each
    other.

5
Process of Installation
  • Advance the insert into the wood (or metal) by
    turning the chuck slowly.
  • The insert must be fully engaged withchuck.
  • Using the wrench the nut should be backed off. 
    You need to reverse the spin of the chuck and
    take the bolt right out.
  • If the top of the insert is not in level, it can
    be driven below using the hex wrench.
    Alternatively, a fine file can be used for
    leveling it.
  • Even if you do not have a drill press, it is
    possible to insert the thread by hand. You may
    find it a little bit difficult in the beginning.
    However, it can be made easy by using the tapered
    styled insert.
  • When the insert is done using a hex wrench, and a
    small square is used, the work becomes easy.
    Also, the insert goes straight in such case.
  • The process explains the installation of brass
    insert in detail.

6
CONTACT US
  • Address Venus Enterprise
  • Road R, Plot no-3973,
    Phase-3, dared,
    Jamnagar-361004, Gujarat, India.
  • Phone 91 9099 408448
  • 91 7405 746564

Website http//vebrassinserts.com/
About PowerShow.com