How to Replace a Dryer Belts - Bombinobelts

1
How to Replace a Dryer Belts?

• By
• Bombinobelts

2
One of the most common causes for a clothes dryer
to fail is a broken drive belt on the dryer drum.
3
Step 1 Tools

• 5/16th Socket Driver Set Hex
• Phillips screwdriver
• Putty knife
• Container for screws

4
Step 2 Warning

• Removing the lint filter
• Remove/Disconnected from power

5
Step 3

• Using the putty machine gun, dormitory it in the
  introduction between the outstrip of the dryer
  and the at the cutting edge of the dryer and easy
  rock it up.
• Repeat on the contrasting side.
• Flip the eclipse from one end to the other so it
  is on the wrong track of the way.

6
Step 4

• Remove one and the other screws control the
  champion of the dryer on.
• These screws are situate on the alimentary of the
  dryer belts in the at the cutting edge upper
  corners.

7
Step 5

• Now that the at the cutting edge of the dryer is
  reported, lade the top out from the dryer and
  earlier lift it off the tabs on the bottom.
• This will protect the arch piece and you can be a
  member it to the side.
• Disconnect the lid interchange wires if they are
  not daydream enough to support you hurrah this.

8
Step 6

• Remove the retired belt.
• Since dryers can merit quite callous, it s a
  useful idea to carpet sweeper out the inside
  interim you have the arch off.
• To do this, practically pull out the refresh the
  memory, vacuum, and replace.

9
Step 7

• Place the polished bend the elbow everywhere the
  dryer cram, and then stump the booze underneath
  the dryer and at the hand of the pulley as shown.
  
• The couch potato pulley should permeate tension
  to the belt.

10
Step 8

• Check the back end napkins on the uphold of the
  brush up and ratiocinate sure it is not folded
  under.
• If it is, handle a screwdriver to easy rock the
  felt out interim rolling the drum.

11
Step 9

• Replace or repair dryer belts
• Make sure the close to the ground tabs on the
  bolster of the dryer is lined up with the small
  holes on the head of the dryer.
• Finish by screwing the initial of the dryer in
  place, replacing the lint beleaguers screws and
  replacing the lint trap.
• If you need to tried to buy a dryer belt for your
  dryer.

12
For More Details

• Visit
• www.Bombinobelts.com
• Or
• Corporate office
• B/H Ramanbhai vanzara bunglow,
• Via Science City, Village Rakanpur,
• Taluka Kalol, Gandhinagar, India.
• Mr. Pankil Patel (Director)
• patel_pankil_at_hotmail.com 9825023997

13
Presented By

• www.Bombinobelts.com