How to Replace the Ink Absorber on a Brother Printer

1
How to Replace the Ink Absorber on a Brother
Printer
2

• Brother printer has an excellent feature of an
  ink absorber pad that soaks up the excess ink
  from the print cartridges, prevent smears and
  keep the cartridge free of dried ink. Many other
  printers manufacturer includes pad such as these
  on their inkjet printer but Brothers pad has a
  unique quality that the printer actively monitors
  the waste ink absorber pads and will display
  error messages when the pads are full of ink. It
  is possible to replace the ink absorber on a
  Brother printer.

3

• We have provided you few steps to accomplish this
  task. You can further give us call on Brother
  printer customer helpline if you will face any
  difficulty while following these steps. You can
  direct interact with our technical experts
  through this Brother printer customer helpline
  number Australia.

4

• Before going to these steps you will require few
  things such as Disposable gloves, Napkin or paper
  towel and Replacement ink absorber pad.
• Step1- Initially, you have to open the printer
  just as when you install new ink cartridges. Let
  the cartridges cradle move to the center of the
  printing unit. Now unplug the printer to stop the
  cartridges in its position

5

• Step2- Now, places the waste ink absorber in its
  black rubber frame. They will be on the right
  side of your printer and located in the area
  where the ink cartridges remain when the printers
  stay in standby mode.
• Step3- later on, use a paper napkin to soak up
  the excess ink that may be in pads by pressing it
  down into the top of the frame

6

• Step4- pulls the rubber frames from the printer,
  wear gloves and now carefully remove the ink
  absorber pad or pad from the rubber frame.
• Step5- Now inserts the new ink absorber pads into
  the rubber frame. Change the rubber frame in its
  original position and then close the printer.

7

• Step6- thereafter, you have to hold down the
  power button and then plug the printer. Keep
  holding the power button until the printer will
  start and reset itself and come online.
• Step7- at the last step waits for the green light
  to turn and the press and release the power
  button again. It should blink for two to three
  seconds, and then stay lit this will indicate
  that the printer has been reset and is ready to
  print again without errors.

8

• If any issues so just call at
• Brother Printer Support Number
• Australia 61-283206033
• Original Source
• http//www.brotherprintersupport.gomilio.com/