A Quasi-Z-Source Direct Matrix Converter Feeding a Vector Controlled Induction Motor Drive || 2015-2016 IEEE Power electronics Projects Training - PowerPoint PPT Presentation

View by Category
About This Presentation
Title:

A Quasi-Z-Source Direct Matrix Converter Feeding a Vector Controlled Induction Motor Drive || 2015-2016 IEEE Power electronics Projects Training

Description:

A Quasi-Z-Source Direct Matrix Converter Feeding a Vector Controlled Induction Motor Drive || 2015-2016 IEEE Power electronics Projects Training Contact: IIS TECHNOOGIES ph:9952077540,landline:044 42637391 mail:info@iistechnologies.in – PowerPoint PPT presentation

Number of Views:26

less

Write a Comment
User Comments (0)
Transcript and Presenter's Notes

Title: A Quasi-Z-Source Direct Matrix Converter Feeding a Vector Controlled Induction Motor Drive || 2015-2016 IEEE Power electronics Projects Training


1
A Quasi-Z-Source Direct Matrix Converter Feeding
a Vector Controlled Induction Motor Drive
  • Presented by
  • IIS TECHNOLOGIES
  • No 40, C-Block,First Floor,HIET Campus,  North
    Parade Road,St.Thomas Mount,  Chennai, Tamil Nadu
    600016.
  • Landline044 4263 7391,mob9952077540.
  • Emailinfo_at_iistechnologies.in,
  • Webwww.iistechnologies.in

2
ABSTRACT
  • This project proposes a novel four-quadrant
    vector controlled induction motor (IM) adjustable
    speed drive (ASD) system based on a recently
    proposed matrix converter topology called
    quasi-Z-source direct matrix converter (QZSDMC).
  • The QZSDMC is formed by cascading the
    quasi-Z-source impedance network and the
    conventional direct matrix converter (DMC).
  • The QZSDMC can provide buck-boost operation with
    voltage transfer ratio controlled by controlling
    the shoot-through duty ratio and bidirectional
    operation capability.
  • The control strategy, which is based on the
    indirect field oriented control algorithm, is
    able to control the motor speed from zero to the
    rated value under full load condition during
    motoring and regenerating operation modes.

3
CIRCUIT DIAGRAM
4
TOOLS AND SOFTWARE USED
  • MP LAB
  • ORCAD/PSPICE
  • MATLAB/SIMULINK

5
OUTPUT
  • HARDWARE
  • SIMULATION

6
Contact
  • IIS TECHNOLOGIES
  • No 40, C-Block,First Floor,HIET Campus,  North
    Parade Road,St.Thomas Mount,  Chennai, Tamil Nadu
    600016.
  • Landline044 4263 7391,mob9952077540.
  • Emailinfo_at_iistechnologies.in,
  • Webwww.iistechnologies.in
About PowerShow.com