1 Connect power cords of the projector A and laptop B into ac outlet C.

1
1) Connect power cords of the projector A and
laptop B into a/c outlet C.
A
B
C
2
2) Connect the VGA cable from the monitor output
of the laptop D to the computer input of the
projector E.
D
E
3
G
F
3) Power up the projector (make sure both the
primary power switch F and stand-by button G
are on) and the laptop.
4
I
4) If the image does not appear on both the
laptop and projector, toggle the image by holding
down both the FN key H and the appropriate
function key I (for IBM it is F7 and Dell
computers is F8). Wait 2 seconds in between
your toggles for the screens to change.
H
5
5) If you have problems getting the image
projected, check to see if the projector is set
to the same input that the VGA cable is plugged
into (eg. Computer In 1 and Computer In 2).
Depending on the model of the projector, press
the mode, input, or source button J until
the source appearing on screen matches the input
you are connected to. Then, repeat step 4.
J
6
6) If you still have problems, check the screen
resolution settings of your laptop by right
clicking on the desktop and choosing Properties
from the menu K.
K
7
In the Display Properties L menu, go to the
Settings M tab to check to see if the Screen
area N setting is more than 1024 by 768
pixels our projectors will only handle
resolution up to 1024 by 768 pixels. If your
resolution is higher than this setting, adjust it
to a setting of 1024 by 768 pixels or less.
Press the Apply button, then press the OK
button.
L
M
N