Electrical Theory I (ENG3322) - PowerPoint PPT Presentation

1 / 23
About This Presentation
Title:

Electrical Theory I (ENG3322)

Description:

Charging of a capacitor One of the functions of a capacitor is its ability to store up charge when a potential difference is applied across the positive and negative ... – PowerPoint PPT presentation

Number of Views:77
Avg rating:3.0/5.0
Slides: 24
Provided by: ee81
Category:

less

Transcript and Presenter's Notes

Title: Electrical Theory I (ENG3322)


1
Charging of a capacitor
  • One of the functions of a capacitor is its
    ability to store up charge when a potential
    difference is applied across the positive and
    negative plates.
  • Energy is stored in the electric field. When a
    voltage is applied across a capacitor, current
    rushes into the plates of the capacitor,
    developing a potential difference across the
    capacitor, therefore the potential difference
    between the battery and the capacitor become
    smaller and the flow rate of electrons become
    smaller.
  • The charging process continues until the
    capacitor becomes fully charged. The charging
    current follows an exponential curve.

2
Charging of a capacitor/2
3
Charging of a capacitor/3
4
Charging of a capacitor/4
  • Insert initial (boundary) conditions, if the
    capacitor is initially uncharged, then at t 0,
    q 0
  • C2 EC, substitute into equation 1

5
Charging Curve
6
Charging Curve
  • From the charging equation, we noticed that the
    rate of charging is determined by the exponential
    curve that is in term determined by the RC
    constant.
  • The term RC is termed the time constant since it
    affects the rate of charge. Mathematically, this
    is the time taken for the capacitor to reach
    0.632 of the fully charged value.

7
Duration of Transient
  • Theoretically, capacitors will never be fully
    charged according to the charging equation.
  • Thus, for all practical purposes, transients can
    be considered to last for only five times of the
    time constant. I.e. the capacitor is said fully
    charged after
  • 5 RC.
  • After 5 time constant, q, Vc and I will be over
    99 to their final values.

8
Charging of Capacitor-Example one
9
Charging of Capacitor-Example one
  • An uncharged capacitor of 2000 micro-Farad is
    connected to a 100 volt D.C. supply in series
    with a current limiting resistor of 5000 Ohms,
    calculate
  • i) The voltage of the capacitor at the end of
    8 seconds charging
  • ii) The charging current at the end of 8
    seconds
  • iii) The time taken for the capacitor to be
    charged to 80 volts.

10
Charging of Capacitor-Solution to Example one
  • 1) Using the charge formula,
  • 2)

11
Charging of Capacitor-Solution to Example one/2
  • 3) For the capacitor to be charged to 80 Volts,
    using the same formula,

12
Charging of a initially charged capacitor
  • If at the start of charging, the capacitor is
    charged to a voltage of E1 Volts,
  • Then at t 0, q E1, substituting this initial
    condition into equation 1, we have

13
Charging of a initially charged capacitor
14
Example to charging of a capacitor with residual
charge and initial voltage
  • A 3,000µF capacitor has an initial voltage of 50
    Volts is further charged by a 200 volts D.C.
    supply in series with a 2 k-Ohm resistor.
    Calculate the voltage across the terminals of the
    capacitor after 10 seconds.
  • Solution Using the formula for capacitor with
    an initial voltage,

15
Alternative solution to previous problem
  • Alternatively, if you do not wish to memorize the
    formula for charging a capacitor with an initial
    charge, you can first find the time required to
    charge an uncharged capacitor to the initial
    voltage, then add the extra time for charging to
    find the final voltage.
  • Solution
  • Time required to charge an uncharged 3,000µF
    capacitor to 50 volts can be found by applying
    the formula

16
Alternative solution to previous problem/2
  • Total time equivalent the capacitor is to be
    charged from zero volt 1.7261 10 11.7261
    Seconds

17
Alternative solution to previous problem/3
  • Final voltage of the capacitor

18
Discharge of a capacitor

19
Discharge of a capacitor/2
  • 0 VR VC

20
Discharge of a capacitor/3
  • Substitute boundary condition, at t 0,
  • Voltage across C E, q EC
  • C2 EC
  • (Note that the negative sign indicate that the
    current is opposite to the charging currents
    direction)

21
Discharge curve
22
Discharge of capacitor example
  • A 1000µF capacitor previously charged to 80
    Volts is to be discharged through a resistance of
    20 k-Ohms. Find the voltage across the terminals
    of the capacitor at the end of 15 seconds.

23
Discharge of capacitor-solution to example
  • Using the discharge formula,
Write a Comment
User Comments (0)
About PowerShow.com