Title: K2 Schematic Analysis and Pictorial Diagram
1K2Schematic Analysisand Pictorial Diagram
2Turn to page K2 in the Student Handout Packet
- Answer the following questions.
3What type of single phase fan motor is used on
this equipment?
4You should notice there are no starting relays
or capacitors. It can only be a Shaded Pole.
5Does the fan and limit have a jumper? Refer back
to K1 if you need help in answering this question.
6Your answer should be YES
7This circuit is for heating only. The fan motor
is only single speed. What is the switching
action of the FR?
8Your answer should be SPDT
9You will now draw thePictorialby following the
Schematic
10The process will be to follow the schematic one
wire at a time from one component to another
component until we are finished.
11- The slides that follow will show the wire in RED
on the schematic that is going to be wired on the
pictorial. Then the pictorial slide will show
that wire being installed. That is the wire
you are to place on your pictorial. Keep
advancing through the slides until you are
finished with the pictorial.
12Turn to page K2a and you will see 1. the 24 v
circuit is completed.2. there is a square
junction box that the wires will run from this
box.
13Square Box
Low Voltage
14(No Transcript)
15Did you get the correct wire for the jumper?
16(No Transcript)
17(No Transcript)
18(No Transcript)
19(No Transcript)
20(No Transcript)
21(No Transcript)
22(No Transcript)
23(No Transcript)
24(No Transcript)
25You have finished a pictorialfollowing
aschematic
26The end