Evaporation - PowerPoint PPT Presentation

1 / 65
About This Presentation
Title:

Evaporation

Description:

cp - specific heat of the atmosphere at ... Saturation vapor pressure (es) - max water vapor holding capacity ... Brackish water. Evaporation Estimation ... – PowerPoint PPT presentation

Number of Views:274
Avg rating:3.0/5.0
Slides: 66
Provided by: mark744
Category:

less

Transcript and Presenter's Notes

Title: Evaporation


1
Evaporation
  • Principles
  • Estimation and analytic techniques

2
Units and Quantities
  • Millibars pressure N/m2
  • Pascals pressure 100 mb
  • cp - specific heat of the atmosphere at constant
    pressure 1004 J/(Kkg)

3
Water Vapor
  • Vapor is a gas
  • Water vapor comprises 4 of well-mixed lower
    portion of atmosphere
  • Saturation vapor pressure (es) - max water vapor
    holding capacity
  • es varies with temperature, pressure and moisture
    content of the air

4
Evaporation
  • Globally 62 of water received at land surface
    is returned by evapotranspiration processes
  • 97 is returned from land surfaces by plant
    processes and evaporation from soil and plant
    surfaces
  • 3 is returned from open water
  • ET amounts usually gtgt runoff

5
Evaporation Process
  • Constant exchange of water molecules between
    liquid and gas phases
  • Some molecules that hit the water surface
    rebound, but capture rate is proportional to rate
    of collision
  • Loss rate is proportional to number of molecules
    that have sufficient energy to escape

6
Factors affecting loss rate
  • Temperature
  • Relative humidity
  • Presence of solutes in water
  • Rate of air exchange over a water surface
  • Amount of solar energy received

7
Potential evaporation
  • Potential quantity of water evaporated per unit
    area per unit time from an idealized, extensive
    free water surface
  • Differs from actual evaporation because
    conditions may be different than those used to
    develop estimates of potential

8
Evapotranspiration (ET)
  • Evaporation and plant transpiration vapor
    transfer are often combined
  • Evaporation estimates are most appropriate for
    open water surfaces
  • In others water vapor transfers by both
    mechanisms are combined

9
Annual potential evapotranspiration v. rainfall
10
Importance of accurate estimation
  • ET equates to water demand for agriculture and
    horticulture
  • ET very significant with respect to quantity and
    quality of reservoirs
  • Evaporated water vapor leaves dissolved solids
    behind, which creates salinity problems in soils
    and surface water bodies

11
Salty water
Concentration (ppm)
Brackish water
Water surface elevation (ft)
12
Evaporation Estimation
  • Based on analog measurements and mass and energy
    transfer concepts
  • Practically applied using weather data (like UNR
    station on Valley Road)
  • Represents application of the Penman equation
    (widely used method for estimating ET combined
    evaporation and transpiration)

13
Approaches
  • ET measurement is difficult, usually must be
    derived from a variety of other measurements
  • Theoretically, by Law of Diffusion
    EKeva(es-ea)E Evaporation rate (L/T)Ke
    coefficient related to vertical transfer of vapor
    by wind va speed of air movement (L/T)(es-ea)
    vapor pressure differences, surface and air
    (M/LT2)

14
Complicating factors
  • Equation is a simple representation of complex
    system of processes
  • Ke cannot be measured directly
  • Air movement can be horizontal and vertical
  • Vapor pressures of both media change with
    temperature and relative humidity
  • Inputs and outputs (rain, solar energy) must be
    accounted for

15
Approaches
  • Analog measurements
  • Water balance and error term estimation
  • Energy balances
  • Combinations
  • Important aspects what is considered,
    technique, required data, expected level of
    accuracy

16
Analog Measurements
  • Class A Evaporation Pans
  • Standardized by U.S. Weather Bureau
  • Most widely applied method for estimating
    potential evapotranspiration
  • One of many designs
  • Very simple to install, operate and maintain

17
Installation requirements
  • Mounted on open wooden frame
  • Bottom .15 m above ground level
  • Water level is within .05 m of the top of the pan
  • Water level fluctuates less than .075 m
  • Protective coverings such as mesh should be
    avoided

18
(No Transcript)
19
Strengths and Weaknesses of Pan Approach
  • Pan reading is sensitive to surroundings
  • Evaporation amount is difficult to relate to crop
    needs
  • Published correction factors (pan coefficients)
    account for a limited range of conditions,
    including relative humidity and wind speeds

20
Pan Coefficients
  • ErcKpanA EpanA
  • rc reference crop (e.g. grass)
  • panA a class A evaporation pan
  • K a coefficient

21
(No Transcript)
22
Calibration KpanA factor
23
Relationship between reference crop estimates and
observed pan evaporation amounts
  • ErcKpanAEpanA
  • As KpanA decreases(increases), the estimated
    amount of actual ET decreases(increases)
  • KpanA 1/f(Wind Speed)
  • KpanA f(Relative Humidity)
  • KpanA f(fetch)
  • Does this make sense?

24
(No Transcript)
25
(No Transcript)
26
(No Transcript)
27
(No Transcript)
28
Seasonal variation of KpanA for corn over the
growing season. In early June, KpanA .4. In
early August .8.
29
Water Balance Approach
  • DS I - O
  • DS Net change in volume of water during time
    interval of interest(Dt)
  • I Influent water (i?Dt)(L3)
  • O Outflowing water (o?Dt)(L3)

30
Aspects of water balance approach
  • What is considered the difference between all
    measurable inflows and outflows
  • EWSWinGWin-SWout-GWout-DV
  • W precipitation
  • GW groundwater flow
  • SW surface water flow
  • DV change in volume

IN
OUT
31
Technique, Required Data
  • Account for all measurable inflows and outflows
  • Account for changes in volume
  • Requires highly accurate estimates of inflow and
    outflow and volume of surface water body
  • Volume estimates come from bathymetric surveys,
    stream gaging stations in inlets and outlets
  • Groundwater flow cannot be measured

EWSWinGWin-SWout-GWout-DV
32
(No Transcript)
33
Expected Level of Accuracy
  • Result incorporates all measurement error
  • Accuracy increases as the accuracy of
    measurements of individual quantities increases
    (importance of error decreases)
  • Under best case result may be ?20
  • Under most cases result may be ?100

34
Example Importance of Measurement Precision
  • Lake Tahoe average surface area 191 mi2
  • .25 drop in water level 2550 aft
  • average daily runoff at Farad, Ca. gaging
    station from 1909-1999

35
Energy balance
  • DS I - O
  • DS ? Net change in stored energy during time
    interval of interest (Dt)
  • I ? Influent energy (i?Dt)(W/m2)
  • O ? Outflowing energy (o?Dt)(W/m2)

36
Elements of Energy Balance Considered
  • DQ QNRQv-(QeQhQw)
  • NR - net solar radiation
  • v - net energy advected
  • e - evaporative energy
  • H - sensible heat

e,H
ea low
Ta low
v
NR
ea high
Ts high
v
37
Developing the Energy Balance with Measurable
Quantities
  • K recd short wave radiation
  • L recd long wave radiation
  • Aw energy recd in water (precip)
  • H sensible heat exchange with atmosphere
  • G heat transfer to soils
  • DQ/Dt change in energy stored in the control
    volume

Qin
Qout
DQ
38
Application
  • ?Q Qin-Qout
  • If ?Q lt0, assume loss of energy from the system
    due to evaporation
  • Use relationships between energy and changes in
    state to estimate mass of water loss
  • Mass is converted to volume (1 gm/cm3)
  • Volume surface area inches evaporated

39
Refinement Combined approach
  • Incorporates mass and energy balance approaches
  • ca - specific heat of the atmosphere at constant
    pressure 1004 J/(Kkg)

40
(T)v
  • E Amount of evaporated water
  • K recd short wave radiation
  • L recd long wave radiation
  • Aw energy recd in water (precipitation,
    inflowing groundwater, surface water)
  • H sensible heat exchange with atmosphere
  • G heat transfer to soils
  • DQ/Dt change in energy stored in the control
    volume

41
?(T)v Latent heat of evaporation as a function
of temperature
  • Latent heat of evaporation ?2.5 kJ needed to
    evaporate 1 gm water
  • ?(T)v 2500.3 - 2.361 T (ºC) (J/g)

42
(T)v
  • What must be measured and how?
  • System is complex, driven by energy gradients
  • Energy gradients include both temperature and
    vapor pressure differences between the free water
    surface and air
  • This implies both sensible and latent heat
    tranfers
  • Involves energy transferred by diffusion and
    turbulent transport (wind)

43
Assumptions
  • On an appropriate time step some elements can be
    considered insignificant
  • Energy gradients (represented by temperature and
    vapor pressure differences between the free water
    surface and air) likely represent the most
    significant routes of energy transfer
  • Energy transfer occurs as sensible and latent
    heat and diffusion and turbulent transport (wind)

44
Penman Assumptions
  • Free water surface (unlimited water supply)
  • No transfer of heat energy between water body and
    surrounding soils
  • No water advected energy enters the system
  • No net change in energy stored within the system

45
K Shortwave solar radiation
  • Relative to surface of reservoir
  • K can be measured, but more likely must be
    estimated
  • Estimation can be done with tables and programs
  • Accurate estimation accounts for changes in
    received solar radiation (date) and cloud cover

46
Estimation of L
  • L sT4(0.5 - .08?e)(0.20.8 (n/N))
  • s Stefan-Boltzmann constant
  • T Average air temperature (ºK)
  • e average vapor pressure (mb)
  • n/N actual v. potential number of hours of
    sunshine received (cloudiness factor)

47
(No Transcript)
48
HKhva(Ts-Ta)
49
Remember Evaporation due to vapor pressure
gradients alone is expressed as E
KEva(es-ea) This assumes that vapor pressure at
a free water surface is the equivalent of
saturated vapor pressure
50
eventually, using the relationship between
relative humidity and saturated vapor pressure,
substitution (using the above) and a relationship
to estimate KH, we end up with the Penman
equation.
51
Penman Equation for Evaporation from a Free Water
Surface
52
Psychrometric constant (mb/C)
53
Measurement Implications
  • Need
  • relative humidity
  • temperature at two elevations
  • estimates of net radiation
  • wind velocity

54
Adaptation for evapotranspiration Estimation
Monteith Modifications
  • Increased wind turbulence effects and
    transpiration quantities due to presence of
    vegetation are addressed partly through
    modifications of KH term
  • For Penman approach
  • caheat capacity of air
  • Z roughness height of surface (0),
    measurementheight (m) and height of reference
    plane (d)

55
Penman Monteith ET Equation
56
ca, Cat, Ccan, ?
  • ca heat capacity of air (.001 MJ/(kgK))
  • Ccan canopy conductance fsLAICleaf
  • fs shelter factor, that accounts for leaf cover
    that leads to lower transpiration rates (.5-1)
  • Cat atmospheric conductance

57
  • zm top of vegetation 2m
  • z0 0.1 zveg (tabled or measured values)
  • zd 0.7 zveg
  • LAI leaf area index (total leaf area with
    respect to equivalent ground area)
  • Cleaf maximum leaf conductance (tabled value)

58
Priestly-Taylor
Assumes that heat flux into the ground (G) is
significant, but treats it as a function of LK
(0.1(LK))
59
Assumes
  • Net energy expended on evaporation lt ((LK)-G)
    (based on assumption that the sensible heat
    gradient is relatively constant)
  • Net energy expended on evaporation gt
    ?/(??)((LK)-G)
  • Can be accounted for with a coefficient (?) such
    that
  • ? lt (? ?) /(?) and ? gt 1

60
Priestly-Taylor
  • Substitutes a proportionality factor for mass
    transfer component of the Penman Monteith model.
  • Estimated average value of 1.26 for short grasses
    and humid conditions.
  • Increased for arid and semi-arid climates.

61
Spreadsheet model of Penman Monteith
  • Penman Monteith Spreadsheet Model
  • Ornamental grass irrigation management
    application http//www.washoeet.dri.edu/washoeEt
    .html

62
  • www.washoeet.dri.edu/washoeEt.html

63
Expected level of accuracy
  • Instrumentation must be available
  • Ignores turbulent, advective transport due to
    wind
  • Relies on few point estimates, which implies
    homogeneity of system within control volume
  • Difficult to apply to mixed or internally
    variable surfaces

64
Summary
  • Discussed different approaches for evaporation
    estimation and combination
  • Mass balance approach requires careful
    measurement of inflows and outflows and reservoir
    of interest
  • Both require careful measurement or accuracy
    suffers
  • Important to understand assumptions

65
Next Time
  • Condensation, precipitation and precipitation
    estimation
Write a Comment
User Comments (0)
About PowerShow.com