PLUS U3810W Projector

1
PLUS U3-810W Projector

• Teacher In-service
• October 23, 2006

2
Installation

• For best results, use in a darkened room.
• Place the unit on a flat, level surface in a dry
  area away from dust and moisture.
• Do not place the unit in direct sunlight, near
  heaters or heat radiating appliances.
• Exposure to direct sunlight, smoke, or steam can
  harm internal components.
• Handle the unit carefully. Dropping or jarring
  can damage internal components.
• Do not place heavy objects on top of the unit.

3
Power Supply

• Handle the power cable carefully and avoid
  excessive bending. A damaged cord can cause
  electric shock or fire.
• Before disconnecting the power cable, make sure
  the POWER indicator lights in amber (not blinking
  or green).
• Disconnect the power cable from the power socket
  after each use.

4
Cleaning

• Disconnect the power cable from unit.
• Clean the outer cabinet of the unit with a soft
  cloth slightly dampened with water only. Never
  use strong or abrasive cleansers.
• Use a blower or lens paper to clean the lens, and
  be careful not to scratch or mar the lens.
• Clean the ventilation slots and speaker grills on
  the unit periodically using a vacuum cleaner.
  Dust accumulations will cause the unit to
  overheat and malfunction.
• Use only a soft brush attachment with the vacuum
  cleaner, not a hard attachment tool such as the
  crevice tool, to prevent damage to the unit.
• You are responsible for cleaning the unit while
  in your possession and prior to returning the
  unit to the Media Center.

5
Lamp Replacement

• Lamps will require replacement after 1000 hours
  of use.
• Lamp should be replaced immediately when the
  STATUS indicator comes on.
• Continued use while the STATUS indicator is on
  will result in damage to the unit.

6
Fire and Shock Precautions

• Make sure there is at least 3 inches of
  ventilation space above and around the unit.
• Prevent foreign objects such as gem clips and
  bits of paper from falling into the unit.
• Do not attempt to retrieve any foreign objects
  from inside the unit.
• Do not insert any metal objects such as a wire or
  screwdriver into the unit.
• If something should fall into the unit,
  immediately disconnect the power cable from and
  return the unit to the Media Specialist. Only
  authorized PLUS service technicians may service
  the unit.
• Do not place any liquids on top of the unit.
• Do not look into the lens while the unit is on.
  Serious damage to your eyes could result .

7
Transportation

• When carrying the unit around, please carry the
  unit in its carrying case.
• To protect the lens from scratches, always shut
  the sliding lens cap.
• Do not subject the unit to strong mechanical
  shock (suddenly applied force or abrupt change in
  motion).

8
Parts Controls
9
Parts Controls Bottom
10
Parts Controls Rear Side Panel View
11
Parts Controls Terminal Panel
12
Wireless Remote Control
13
Wireless Remote Control
14
Wireless Remote Control
15
Connecting Equipment

• Up to two pieces of equipment can be connected to
  the unit.
• You can switch the input source (picture) to
  VIDEO or S-VIDEO when you connect two pieces of
  equipment.
• You can output the sound of only one source
  through the unit speaker when two components are
  connected.

16
Connection to the Video Jack
17
Connection to the S-Video Jack
18
Connecting to a PC
19
Operation
Step 1
20
Step 2
21
Step 3
22
Step 4
23
Step 5
24
Step 6
25
Adjusting Height
Lift front of the unit to the desired
height. Press the adjuster button on the top
front of unit and the adjuster legs will drop
into place. Release the adjuster button to lock
the adjuster legs in position. Rotate the rear
adjuster button to level the unit.
26
Focus the Image

• Use the focus ring to adjust the image focus.

27
After Use Instructions

• Press the POWER button of the remote control or
  the POWER button of the main unit for a few
  seconds.
• The power will turn off and the POWER indicator
  will blink for 1 minute, then the standby status
  will be activated. (The exhaust fan will continue
  to run for awhile for cooling purposes.)
• Do not unplug the power cord while the indicator
  is blinking.
• Once the indicator stops blinking, unplug the
  power cord.

28
Check Out/In Procedures

• Projectors will be available for check out
  through the Media Center.
• Teachers must attend in-service and be
  certified prior to checking out a projector.
• ALWAYS return the unit to the Media Center after
  use....NEVER pass the unit to another
  teacher/classroom without first checking the unit
  in through the Media Center.
• You are responsible for the care, proper use and
  storage of the unit while it is checked out to
  you.
• Be prepared, you may receive a spot check while
  the unit is in your possession.