A Survey of Aeroacoustic Considerations in Wind Turbines - PowerPoint PPT Presentation

1 / 21
About This Presentation
Title:

A Survey of Aeroacoustic Considerations in Wind Turbines

Description:

A Survey of Aeroacoustic Considerations in Wind Turbines – PowerPoint PPT presentation

Number of Views:56
Avg rating:3.0/5.0
Slides: 22
Provided by: robert908
Learn more at: https://sites.gatech.edu
Category:

less

Transcript and Presenter's Notes

Title: A Survey of Aeroacoustic Considerations in Wind Turbines


1
A Survey of Aeroacoustic Considerations in Wind
Turbines
  • Robert Scott
  • AE 6060

2
Outline
  • Introduction
  • Mechanisms
  • Prediction
  • Measurement
  • Effects
  • Suppression
  • Conclusions

3
Introduction
  • Clean energy
  • Opposition to wind energy development (NIMBY)
  • Appearance
  • Sound
  • Cape Wind Project
  • Small Wind Turbines

4
Mechanical Noise
  • Sources
  • Gearbox
  • Generator Shaft
  • Cooling Fans
  • Yaw/Blade Pitch motors

5
Low Frequency Noise
  • Thickness negligible
  • Low local speed
  • Unsteady Loading
  • Blade passes through towers wake.

6
Inflow-Turbulence Noise
Blade encountering natural atmospheric turbulence
causes broadband noise radiation. Size of
turbulent eddies determines frequency. (5 Hz 1
kHz)
7
Airfoil Self Noise
  • Trailing Edge Noise
  • Turbulent eddies enhanced by trailing edge
  • Broadband
  • Vortex Shedding
  • Trailing edge noise creates B-L instabilities
  • Tonal
  • Re lt 106

8
Airfoil Self Noise
  • Tip Noise
  • Tip vortices
  • Side edge
  • Broadband
  • Separation Noise
  • Deep Stall
  • Entire chord radiates sound
  • Broadband

9
Airfoil Self Noise
  • Trailing Edge Bluntness Noise
  • T-E thickness causes vortex shedding
  • Tonal
  • Surface Imperfections
  • Dirt, bugs, damage
  • Broadband

10
Typical Noise Spectrum
11
Prediction
  • Codes can predict low frequency noise based on
    FW-H Eqn.
  • Empirical methods, approximations to flat plates
    used to predict noise due to turbulence.

3-blade downwind, 60 rpm
NACA 0012, S822 predicted T-E noise
12
Prediction
Rules of thumb
(1)
(2)
(3)
Based on rated power capacity, rotor diameter,
and tip speed. Tested these formulas for a wind
turbine with available information
Actual Tests
Predictions
AOC 15/50
13
Measurement
Array placed upwind of wind turbine
Concentration of sources on downward side due
to Doppler amplification 0-12 dB scale
14
Measurement
Shift in source location corresponding to
alignment angle. Region of sources in area
of maximum relative velocity to array.
15
Effects
for latest generation utility-scale turbines
Even at distances lt1 km from site, wind turbine
noise may be completely drowned out by ambient
noise due to the wind.
16
Effects
  • Low frequency noise could conceivably cause
    windows to rattle or slight infrasound
    discomfort.
  • Still not likely unless very close to wind
    turbine.

17
Suppression
  • Mechanical Noise
  • Early wind turbines
  • Exposed machinery, large contribution of
    mechanical noise
  • New wind turbines
  • Nacelle covering with acoustic treatment on
    inside nearly eliminates mechanical noise.

18
Suppression
  • Aerodynamic Noise
  • Operation
  • Lower tip speed
  • Decrease blade pitch
  • Both options not ideal
  • Design
  • Configurations
  • Upwind less sensitive to inflow turbulence
  • Blade Design
  • Airfoils
  • Tip Shapes

19
Suppression
  • Clean airfoil with low T-E thickness will have
    low tonal noise due to less vortex shedding.
  • Rounded, serrated, and porous trailing edges can
    reduce acoustic efficiency of trailing edge noise.

ref
gt300
40
250
1
lt1
20
Suppression
  • Dirt, bugs on blades detach flow
  • Noise due to imperfections
  • Loss of blade performance
  • Water jets clean blades

21
Conclusions
  • Annoyance due to large wind turbines unlikely.
  • Small wind turbines actually pose bigger noise
    problem.
  • Continuing improvements will reduce noise even
    further.
Write a Comment
User Comments (0)
About PowerShow.com