Title: 5 Common Plumbing Mistakes to Avoid to Save Money in Menifee, CA
14 COMMON PLUMBING MISTAKES TO AVOID TO SAVE MONEY
IN MENIFEE, CA
www.lnsturnkey.com
2Introduction
As a homeowner, protecting your plumbing system
is a huge responsibility. Given its importance
for your home and the time and money that goes
into its maintenance and repair, it requires that
much attention. So, do not take chances and know
the common plumbing mistakes to avoid.
www.lnsturnkey.com
31.MISTAKES DURING DIY
Money is an influencing factor when deciding on a
plumbing repair. It is also why people end up
doing DIYs, which, a lot of times, can cost more
if they go wrong. Using blow torches as a heat
source for frozen pipes might cause bursting due
to rapid expansion. Turning off the water line is
another mistake people make while starting the
repair work. Firstly, know the location of the
main valve and remember to turn off. A minor
fault during DIY repair can cause a lot of water
damage.
www.lnsturnkey.com
42.LEAVING LEAKY FAUCETS AS IS
Leaky faucets are an annoying site leaving them
would only aggravate the situation. Not only does
it increase your water bills, but also, damages
the faucet, causing corrosion and mold growth.
Corrosion damage and mold growth require separate
treatments that can cost you double than getting
the faucet repaired.
www.lnsturnkey.com
53. OVERUSE OF CHEMICAL DRAIN CLEANERS
We often use chemical cleaners to clean out
drains. But do we understand that they can be
damaging to your plumbing system? These are harsh
chemicals, when used in excess, can erode pipes
and their finishing. Some even harm the
environment. You may save money initially with
the use of unclogging powders. But it is better
to get an expert for unclogging so that chemicals
do not further affect the pipe system.
www.lnsturnkey.com
64. OVERTIGHTENING CONNECTIONS
The use of excess force for tightening is
damaging in the long run. Eventually, it will
result in a leak. Fittings such as elbows and
tees, if cranked too hard, cause cracks and make
repairs difficult later, which ultimately calls
for a technician. Overtightening Fittings on the
toilet, such as bolts between the bowl and tank,
is an example. Actually it does not require this
much force to tighten a water line.
www.lnsturnkey.com
7Contact Us
1 (951-999-4993)
www.lnsturnkey.com
info_at_lnsturnkey.com
8THANK YOU
FOR YOUR ATTENTION
www.reallygreatsite.com