johnwilsonjohn039

1
(No Transcript)
2
Introduction
The SMOK Fetch Mini is a 40W starter kit. This is
a visually stunning pod system with a beautiful
AG Glass panels. It also includes 1200mAh
battery and an advanced chipset with 40W max
output. The Intuitive 0.96OLED display and RPM
coil technology adds to its list of stunning
features. This is a modernized all-in-one (AIO)
structure that is portable and elevated to
high-performance. Vapers who wish to try
something new can get their hands on this device.
3
Design And Built Quality
To start with, the device has been powered by an
in-built battery worth 1200mAh. The adjustable
output varies in the tune of 5W and 40W. With
this range the device meets different vaping
requirements of the users. The Fetch Mini has a
3.7ml of e-juice capacity. This is sufficient to
meet the demand of vapers. The kit also comes
with an easy bottom filling design. It allows
easy refilling of e-juice.
4
Battery Performance
The SMOKTech pod system comes with a 1200mAh
internal battery capacity along with variable
wattage support of 40W. On the left side of the
battery you can find the 0.96 inch screen, a
firing button and USB charging port along with
up/down button. Apart from this, the device
supports Micro USB port for charging. So, you
can charge the device when it runs out of charge
and enjoy vaping anytime, anywhere as per your
need. In fact, the device gets fully charged in
just 55 minutes.
5
Supported Coils
The SMOK Fetch Mini RPM pod and Nord pod are
compatible with RPM coils and Nord coils
simultaneously. These have been distinguished by
rubber plug color and the corresponding text on
the rubber plug. The RPM coils have been fully
upgraded with bigger volume, thicker cotton and
large airway. It is also almost the same huge
vapor like the TF series and ultimate taste of
the Nord Coils.
6
Build Your Own RPM RBA
Benefits of RBA The main benefit of using RBAs
is that you can build your own coils through
which you can choose the resistance according to
your will.
How to Build Step 1 Before you start, you must
ensure that your hands are thoroughly clean.
Step 2 You must take the RBA deck apart
carefully. Dont be in a hurry it may cause a
mess.
Continue To Next Slide
7
Build Your Own RPM RBA
How to Build Step 3 install and position the
pre-wrapped coil. Place the coil between the
posts and wrap the ends around screws and tighten
up. Ensure coil doesnt touch the base. Step 4
Carefully cut the wire ends off. You need to use
proper tools for that. Step 5 Cut the strip of
cotton and make sure it is not too much nor too
less. Step 6 Inserting the cotton and placing
it in the middle is the next thing you must
do. Step 7. Cutting the cotton at an angle and
ensure it is either too short nor too long. Step
8 Wet the coil with the e-juice and adjust the
cotton. check coil for resistance before these
are fired on the device.
8
Thank You
Get Your SMOK Fetch Mini Kit From CSVape
https//csvape.com/smok-fetch-mini-kit.html