MIG Wire (1)

1
MIG Wire

• http//www.dnhsecheron.com/

2
Mig Welding Tips
Here is my list of MIG Wire welding tips that I
think can make a real difference to you when you
are using your wire feed welder.
1. Clean materials. You should always work with
clean materials. Make sure that the metal you are
going to weld is clean and free from anything
that can contaminate the weld. Anything like rust
particularly heavy rust, old paint, grease and
any oils need to be removed before you MIG weld
Welding Consumables
3

• 2. Earth clamp. The Earth clamp is often
  overlooked when people start having mig welding
  problems. You've got to understand that when you
  are welding you are essentially creating a big
  electrical circuit. Any break in the circuit will
  cause you troubles. So check your earth clamp to
  make sure that everything is secure and that the
  contact points are clean. You might need to touch
  them up with some sand paper.

Welding Machine
4

• 3. Gasless mig wire. It's a known fact that the
  self shielding flux core wires make a fair amount
  of welding spatter. One of the best things you
  can do is to use some anti spatter. It is
  available in aerosol cans and liquid form where
  you can fill up a spray bottle and squeeze it on
  by hand. Another little tip, make sure you get
  the least toxic stuff available, some of them are
  pretty bad to your health.
• 4. Mig welding wire. Use the best possible
  welding wire that you can get your hands on.
  There's so much rubbish wire out there in the
  marketplace that most of the time they do more
  damage than good. A good mig wire will be
  accurate in its dimension throughout the whole
  spool. A decent mig wire will also have a very
  good copper coating on it. The wire should never
  go over size either.

5

• 5. Mig welding tips. If you're having trouble
  with bad welds and wire sticking, one area to
  look at may be the contact tips. With a lot of
  the cheaper contact tips the internal bore of the
  hole that the wire has to travel through can be
  very rough, course and uneven. This can lead to
  erratic and unstable arcs, wire burn backs,
  erratic feeding and higher consumable costs.
• Sometimes it really does pay just to use genuine
  parts.
• Article Source http//EzineArticles.com/2646427

6

• DH Sécheron is one of the leading welding
  manufacturers in India. Incepted in 1966, DH
  Sécheron is an ISO 9001-2015 certified company
  that offers a comprehensive range of welding
  solutions in the form of consumables,
  equipment's, training and fabrication.
• Get in touch with us on.
• DH Secheron
• Facebook
• Twitter
• Google Plus