Top 5 Steps to Reset your Brother LC51 Printer Cartridge

1
The Brother Printer cartridges like the LC51
include a sensor that points out the LED light
within your printer to check the ink level. If
there is ink in the print cartridge, then the LED
light cant go through it, and your Brother
Printer works usually. However, if the light can
go through the cartridge, the sensor encounters
the ink cartridge errors by assuming that the ink
runs out even if there is still ink in the
cartridge. In such a case, you can contact the
Brother Printers support number for further
assistance.
2
If youre getting the low ink error, then reset
the print cartridge to assume your printer is
that it is full and start using the cartridge
having the sensor. To reset the Brother LC51.
3

• Check the Following process
• Step 1 Power on your Brother LC51 printer, and
  then open the cover of the machine, and take the
  color ink cartridge out thats showing the error
  code on your PC.
• Step 2 Cut off the part of electric tape
  approx. 1/2 inch lengths. On the other hand, you
  can use the clear tape and blacken it using a
  black marker.
• Note In case you require expert guidance, call
  at the Brother Customer service number for
  further assistance.
• Step 3 Rotate the print cartridge reversed, and
  put the electrical tape on the lower part of the
  print cartridge, wrapping the square groove in
  the middle that has a slot in it. Push the tape
  along the corners to make sure that observes to
  the cartridge.
• Step 4 Change the print cartridge in your
  Brother printer. Lock the case and hit the
  Power button to switch the LC51 printer off.
  Disconnect the electrical cable from the back of
  your printer for at least 30 seconds.
• Step 5 Connect the electrical cable into the
  power slot, and switch your printer on. Follow
  the same process for each ink cartridge that is
  showing the error message.

4

• 
  contactforhelp.com/brother-printer-support/
• 
  facebook.com/contactforhelpus