Carpet And Flooring Installation In New York City

1
Carpet Flooring Installation
2
What is Carpet?
A carpet is a textile floor covering consisting
of an upper layer of pile attached to a backing.
The pile is generally either made from wool or a
fiber such as nylon or polyester. Carpet is
either manmade and machine made. If you are
looking for Carpet and Flooring Installation in
New York City you can contact us.
3
CARPET INSTALLATION TOOLS

• Adhesive Nozzle, Spreads
• Carpet Seam Roller
• Loop Pile Cutter
• Carpet Trimmer
• Carpet Knife
• Knee Kicker
• Scissor

• Double Sided Tape
• Measuring Tape
• Steel Channel
• Adhesive
• Underlay
• Chalk

4
INSTALLATION PROCESS

• Determine the Area
• First of all we must know the area where
  carpeting needs to be done. Dimension of the area
  will define the amount of carpet we require.
• Clean the Subfloor
• Cleaning of subfloor is important. It should be
  free from dust, dirt and moisture and it must be
  smooth too.

5
INSTALLATION PROCESS

• Lay the Underlay
• This is also known as carpet pad. It is laid over
  subfloor using adhesive and it is available in
  different material sponge rubber, foam. It also
  gives cushioned feeling while walking over it.
• Trim the Underlay
• Underlay should not be overlapped to each other.
  So trimming should be done properly.

6
INSTALLATION PROCESS

• Trim the Carpet to Size
• Cut the carpet 3 bigger than the area where it
  should be installed. 3 extra is taken for error
  and to match the pattern and design of the
  carpet.
• Apply Adhesive
• Apply the adhesive on bottom of the carpet.
• Usually synthetic adhesive is used.

7
INSTALLATION PROCESS

• Lay the Carpet
• Carpet is laid by side by side keeping in mind
  its pattern, design and edges where it should
  join to other piece of carpet. It should not
  overlap on each other and also do not allow the
  air between carpet and underlay.
• Stretch the Carpet
• Stretch the carpet from all the sides with hands
  and with knee kicker. It should not be stretched
  too much.

8
INSTALLATION PROCESS

• Attach the Edge of the Carpet
• Attach the edges of the carpet. Here joining of
  pattern and design is important. Because one inch
  difference can spoil entire flooring
• Cut the Excess Carpet
• After adjusting from all the sides. There will be
  excess carpet that should be trimmed.
• Tuck the Edge of the Carpet
• Tuck the edges of the carpet from all the sides
  in steel channel. Steel channels are available in
  different width.

9
Thank You
Shared By Bay Ridge Carpet Linoleum http//bay
ridgecarpet.com email bayridgecpt_at_gmail.com Phone
[phone]