Analysis of Dual-Carrier Modulator for Bidirectional Non inverting Buck–Boost Converter || 2015-2016 IEEE Power electronics Projects Training

1
Analysis of Dual-Carrier Modulator for
BidirectionalNon inverting BuckBoost Converter

• Presented by
• IIS TECHNOLOGIES
• No 40, C-Block,First Floor,HIET Campus, North
  Parade Road,St.Thomas Mount, Chennai, Tamil Nadu
  600016.
• Landline044 4263 7391,mob9952077540.
• Emailinfo_at_iistechnologies.in,
• Webwww.iistechnologies.in

2
ABSTRACT

• A pulse-width modulation modulator for a non
  inverting bidirectional buckboost converter is
  analyzed and a corresponding average-mode current
  controller design is revealed.
• The main feature of the modulator is the ability
  to create switching sequences for both converter
  legs without requiring any information regarding
  either operation mode or the direction of power
  flow.
• The modulator receives a control signal generated
  by the current controller, and a triangular
  carrier and generates driving signals with two
  different duty cycles, allowing tight control of
  the inductor current throughout the entire
  operating range.

3
CIRCUIT DIAGRAM
4
TOOLS AND SOFTWARE USED

• MP LAB
• ORCAD/PSPICE
• MATLAB/SIMULINK

5
OUTPUT

• HARDWARE
• SIMULATION

6
Contact

• IIS TECHNOLOGIES
• No 40, C-Block,First Floor,HIET Campus, North
  Parade Road,St.Thomas Mount, Chennai, Tamil Nadu
  600016.
• Landline044 4263 7391,mob9952077540.
• Emailinfo_at_iistechnologies.in,
• Webwww.iistechnologies.in