Provisional plans for the use of Space in a 5 6m Area

1
Provisional plans for the use of Space in a 5
6m Area (UL Mountainbike Club)
???
????
Plug Socket Workbench Area Hatched area has
nothing below it to allow people to sit at the
workbench Light Switches. Area should be brightly
lit. Bench Vice Bolted to the Bench Surface
2
Notes

• Floor should be hard wearing and moppable
• Workbench Area Large cupboards should be
  available for storage of helmets/other equipment
  under the Workbench and sink. Hatched area has
  nothing below it to allow people to sit at the
  workbench. Workbench should be at similar height
  to a kitchen worktop
• Wall behind the workbench is covered with slotted
  wall covering allowing shelves/bins for tool
  storage to be fitted where needed
• Sink (Should supply Drinking Water)
• Outer limit of the space taken up by bikes in
  storage
• Bar 50mm Ø min, set at approx 2.1m Above ground
  level. This allows bikes to be hung by their
  saddles for storage. More bikes can then be
  stored on the ground under the bikes hung on the
  rail. Vertical Supports approximately every 2m
• Entrance doors. Double doors approx 2.2m high by
  2m wide will allow the club trailer to be wheeled
  into the workshop if work needs to be done on it
  or if the trailer is to be packed the night
  before departing on club trips. Doors and locks
  should resist attempts to break in as bikes and
  cycling equipment and tools are expensive, easily
  stolen and easily sold on
• The area outside the building should also have
  secure fencing in order to allow safe parking of
  club trailers and cars outside the building if
  required
• A tap with a hose and a drain outside the
  building will be needed to clean bikes after use
• Club members will need access to toilet and
  shower facilities in the building