Columns and Supplies - PowerPoint PPT Presentation

About This Presentation
Title:

Columns and Supplies

Description:

After it effused completely, the cartridge was washed with 3 mL water (pH ... The cartridge was dried under a negative pressure (below 2.0 kPa) for 3 minutes ... – PowerPoint PPT presentation

Number of Views:121
Avg rating:3.0/5.0
Slides: 17
Provided by: chemAg
Category:
Tags: columns | supplies

less

Transcript and Presenter's Notes

Title: Columns and Supplies


1
Tetracyclines in Chicken using Solid Phase
Extraction (SPE) and HPLC/UV
  • Chen-Hao (Andy) Zhai
  • Agilent Technologies
  • October 2008

2
Abstract
  • A method for the determination of residual
    Tetracyclines in chicken has been established
  • Tetracyclines were extracted from chicken with
    EDTA-McIlvaine buffer
  • Clean up was performed using Agilent SampliQ OPT
    solid phase extraction cartridges
  • Eluate was analyzed by HPLC with DAD
  • Limits of detection (LOD) were between 2.5 and 5
    ug/kg
  • Calibration curves were linear over the range of
    25 to 500 ug/kg
  • Recoveries based on solution standards were
    between 52.0 and 99.0 with RSD (n6) values
    between 1.0 and 6.5

3
Introduction
  • Tetracyclines is the name used for a class of
    antimicrobials which all contain a
    hydronaphthacene backbone.
  • Effective against a wide range of gram negative
    and gram positive micro-organisms.
  • Most governments now regulate the amount of
    residual tetracyclines found in food,
    particularly animal tissues

4
Materials
  • Standards All reagents and solvents were HPLC or
    analytical grade
  • Tetracycline standards were purchased from
    Sigma-Aldrich or NICPBP
  • Stock solution (0.1mg/mL) prepared in methanol
    and kept in the freezer (-20C)
  • Working solutions prepared using the stock
    solution diluted with a mixture of methanol /
    10mM trifluoroacetic acid solution (1/19)
  • Working solutions prepared daily
  • SPE cartridges Agilent SampliQ OPT 3mL, 60mg
    (Part 5982-3036)
  • Solutions McIlvaine buffer, mix 1000mL 0.1M
    citric acid with 625mL 0.2M disodium hydrogen
    phosphate (pH adjusted to 4.0 0.05 with NaOH or
    HCL as needed)
  • Na2EDTA-McIlvaine buffer (0.1M), mix 60.5g
    Na2EDTA.2H2O into 1625 mL McIlvaine buffer.
  • 10mM TFA solution 0.765 mL trifluoroacetic acid
    dissolved in water to a final volume of 1000mL.
  • Methanol-TFA solution 5 methanol in 10mM TFA
    solution

5
Materials and Methods HPLC
  • Chromatography System Agilent 1200 HPLC ,
    quarternary pump, autosampler, thermostatic
    column compartment, diode array detector
  • HPLC conditions
  • Column Agilent Zorbax SB-C8 2504.6mm 5µm (Part
    880975-906).
  • Flow rate 1.5ml/min
  • Column Temperature 30oC
  • Injection volume 100µl
  • Detector wavelength 350nm
  • Mobile phase 10 mmol/L TFA solution, methanol,
    acetonitrile, gradient elution

6
Methods Sample Preparation
Table 1 Physical-Chemical Properties of
Selected Tetracyclines
  • The physical-chemical properties of the seven
    tetracyclines compounds are shown in Table 1 and
    the chemical structures are shown in Fig. 1
  • The method used for the preparation of the
    chicken tissue is shown schematically in Fig. 2
  • 200g chicken was homogenized and placed in a
    clean, sealed container and stored at -18oC
  • 5g homogeneous sample (accurate to 0.01 g) was
    placed into a 50 mL polypropylene centrifugal
    tube with 20mL 0.1 mol/L Na2EDTA-Mcllvaine buffer
    solution and vortexed for 1 minute followed by a
    10 minute ultrasonic extraction in an ice bath.
  • Sample was then centrifuged at a speed of 3000
    r/min for 5 minutes (below 15oC).
  • The supernatant was removed and saved in a clean
    tube.
  • The extraction was repeated twice with 20mL and
    10mL successively and the combined supernatants
    were brought to 50 mL with buffer, mixed well,
    and centrifuged at a rotate speed of 4000 r/min
    for 10 min (below 15oC), then filtered.

7
Chemical Structures of Tetracyclines
8
SampliQ OPT Sample Preparation Chicken Muscle
Accurately weigh 5g raw, homogenized chicken meat,
Homogenize 1 min. in 20mL 0.1M Na2EDTA-McIlvaine
buffer
Ultrasonic extraction in ice bath for 10 min.
Centrifuge 3000rpm 5min transfer supernatant to
centrifuge tube B
repeat 2x, 20mL and 10mL successively
Bring total supernatant to 50mL final vol.
Centrifuge at 4000 rpm for 10 min.
Filter, take 10mL for SPE
9
Methods SPE Purification
  • The procedure used for the SPE extraction is
    shown in Figure 3
  • Agilent SampliQ OPT cartridges were
    preconditioned with 5mL methanol then 5mL 10mM
    TFA solution.
  • 10 mL extract (equivalent to 1 g sample) was
    passed through the SampliQ OPT cartridge at a
    speed of 1mL/min.
  • After it effused completely, the cartridge was
    washed with 3 mL water (pH adjusted to 4.5 with
    TFA) and the entire effluent was discarded.
  • The cartridge was dried under a negative pressure
    (below 2.0 kPa) for 3 minutes
  • Sample is eluted with 10ml of 10mmol oxalic acid
    in methanol (Oxalic acid acts as a chelating
    agent and maintains the pH where tetracyclines
    are most stable)
  • Eluent was collected and dried under nitrogen
    below 40oC.
  • Residue was dissolved and made to a constant
    volume of 0.5mL using the methanol-TFA solution,
    filtered through a 0.45 µm filter membrane, and
    analyzed

10
SampliQ OPT Process for 3mL Cartridge
Condition 5mL methanol
Equilibrate 5mL 10mM TFA (pH 2.16)
Load 10mL extract (equivalent to 1g meat)
Recommended flow through cartridge not faster
than 1mL per minute
Wash 3mL water (adjust pH to 4.5 w/ TFA)
Dry 3 minutes under vacuum
Elute with 8mL 10mM Oxalic acid in MeOH
Dry, reconstitute in 5 MeOH 10mM TFA
Filter
11
Results - Linearity and Limits of Detection
  • Stock solutions were diluted to different
    concentrations and analyzed by HPLC
  • Linear regressions were calculated for the
    tetracyclines based on the areas and the solution
    concentrations
  • Limit of detection (LOD) was the injection
    concentration which signal to noise ratio was
    between 2 and 3
  • Linear range was between 25-500µg/kg. The
    linearity and LOD are shown in Table 2

Table 2. Linearity and LODs of Tetracyclines
12
Recovery and Reproducibility
  • The precision of the method was determined as
    recoveries of spiked tetracycline standards in
    chicken at 50µg/kg, 100µg/kg and 200µg/kg levels
  • The analysis was performed in replicates of 6 at
    each level
  • The chromatograms of the blank and spiked
    standard are shown in Figure 4 and Figure 5.
  • The recovery and reproducibility data are shown
    in Table 3.

13
Figure 4. Chromatogram of chicken blank
Figure 5. Chromatogram of a chicken sample spiked
with 1-minocycline, 2-oxytetracycline,
3-tetracycline, 4-demeclocycline,
5-chlortetracycline, 6-demeclocycline,
7-doxycycline
14
Recoveries and RSDs of Tetracyclines in Chicken
15
Conclusion
  • Agilents SampliQ OPT, a polymeric sorbent with
    combined hydrophilic and lipophilic
    characteristics that allows retention of both
    polar and non-polar compounds, provides a
    simplified and effective single cartridge method
    for the purification and enrichment of multiple
    tetracycline compounds in chicken
  • Recovery and reproducibility (routinely below 5)
    based on solution standards are acceptable for
    tetracycline residue determination in chicken
    under the Chinese regulation
  • Impurities from chicken were minimal and did not
    interference with any of the tetracyclines
    analyzed
  • LODs of the 7 tetracyclines were much lower than
    the MRL (100µg/kg)

16
Reference
GB/T 21317-2007, Determination of tetracyclines
residues in food of animal originLC-MS/MS method
and HPLC method
Write a Comment
User Comments (0)
About PowerShow.com