Radial Arm Saw Safety & Operation The radial arm saw is use

1
Radial Arm Saw Safety Operation

• The radial arm saw is used for cross cuts to cut
  stock to rough length.
• The motor and blade are carried on an overhead
  arm while the stock is held against a fence.

2
Pre-operation Safety

• Before turning on the motor be sure that all
  clamps and locking devices are tight and the
  depth of cut is correct.

3
Pre-operation Safety

• Keep the guard in place and be sure it is
  operating freely.
• Be sure the cradle rolls freely and is not loose
  or wobbly on the rollers.

4
Operation Safety

• MAINTAIN A 6in. MARGIN OF SAFETY.
• Your hands must never be inside the safety zone
  or within 6in. of the path of the saw blade.

5
Operation Safety

• Stock must be held firmly on the table and
  against the fence.
• The ends of long boards must be supported level
  with the table.

6
Operation Safety

• When cutting, stand to the side of the saw
  maintaining a firm grip with a bent elbow to
  prevent the saw from climbing over the material.

7
Operation Safety

• Always return the saw to the rear of the table
  and lock in place after completing a cut.
• Never remove stock until the saw has been
  returned and locked in place.

8
Operation Safety

• Always keep your eyes on your work.
• Do not be distracted from your work.

9
Final Safety Points

• Always wear safety glasses or shield when
  operating the radial arm saw.
• Shut off motor and wait for blade to stop before
  making any adjustments.
• Be sure the blade has stopped before you leave
  the machine.
• The table should be kept clean and free of scrap
  pieces and excessive sawdust.