Introducing the Mobile Sink with Cabinet Base and Self Contained Water Supply

1
BH, Inc.
Introducing the Mobile Sink with Cabinet Base and
Self Contained Water Supply
2
Picture shows MSK/Cabinet Base - Standard Unit
Note This unit shows the standard faucet. The
following pictures show unit with IR faucet
option.
3
Note Pictures shows sink with a custom shelf
attached and IR Faucet and soap
dispenser options
------------------------------IR Faucet
-------------------Soap Dispenser
Front view
Red switch turns power on to sink. Below it is
charging port for unit battery.
A Standard 120 VAC cord plug is supplied with
adapter to plug into charge receptacle for the
purpose of charging the battery on the MSK with
self contained water supply system
Fresh Water Reservoir ----------------------------
------
4
Back View
Waste Water Reservoir
5
Left Side View
IR Module --------------------------
Pressure Unit ------------------------------------
-----
Pump ---------------------------------------------
-------
6
Right Side View
Unit Battery -------------------------------------
------------
Soap Dispenser Reservoir--------------------------
-----------------------
7
When the Self-Contained option is installed,
water is supplied by filling the Clean Water
Reservoir with water and connecting the hoses
from the faucets to the outlet fittings from the
water pump the Waste Water Reservoir should be
empty. The Clean Water Reservoir may be filled
with a hose from the facility supply through the
large filler cap on the front of the container
which is accessed inside the hinged door on the
front of the unit.   The water temperature
discharged from the faucet is regulated by
filling the Clean Water Reservoir with water of
the desired temperature.  
8
With the battery fully charged, turn the pump
switch to the ON-RUN position, the pump will
start as soon as either faucet is opened, and
the pressure drops in the water supply system.
The pump will continue to pump water to the basin
as long as the faucet is open. When both of the
water faucets are closed, the pump
automatically stops as the pressure builds in the
system. When not in use, place the pump switch
in the OFF-CHARGE position.   Failure to
turn off the pump switch may cause the pump to
start and stop if the faucet is left cracked
open.  
9
Waste Water The sink drain is provided with a
flexible drain hose which must be inserted into a
floor drain. If a floor drain is not available,
an optional waste water container (Model
CB/MSK-P) may be used.  The Self Contained
option includes a Waste Water Receptacle. The
flexible drain hose must be inserted into the
large Filler Opening on the Waste Water
Receptacle. The Waste Water Receptacle is
positioned to hold more water than can be carried
in the Clean Water Reservoir, provided it is
drained completely each time the Clean Water
Reservoir is filled. The waste water container
may be drained into a sewer through the spigot
provided on the bottom of the container that is
accessed inside the rear hinged door on the
enclosed cabinet model. The Waste Water
Reservoir may also be removed and emptied
through the large filler opening on the top. The
clean and waste water containers may be
autoclaved.  
10
Battery Pac - 12 Volt and Charger The sealed
lead acid (Gel Cell) 12 volt rechargeable battery
pac is located on the right side of the sink
under the basin. A rocker type ON - OFF
switch is located on the front of the cabinet
along with a female type plug receptacle. The
switch must be in the ON-RUN position for the
pump to run when the cold water faucet is opened.
To turn the switch ON, press the end opposite
the white dot.   To charge the battery, when the
sink is not being used, the cigarette
lighter-type male plug must be inserted into the
female plug receptacle on the front of the
cabinet with the switch in the OFF-CHARGE
position. To place the switch in the OFF
position, push the end with the white spot. (See
the manufacturers literature enclosed for more
detailed instructions.)